Fisher-Price Fun 2 Learn K7926 User manual

1.5V x 3
“C” (LR14)
Shown Actual Size
www.fisher-price.com
Toby the
Totbot
K7926
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “C” batteries (included).
Adult assembly is required for battery replacement.
Tool required for battery replacement:
Phillips screwdriver (not included).
Battery Replacement Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause
a chemical burn injury or ruin your
product. To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted
batteries from the product. Dispose of batteries safely. Do not dispose of this
product in a fire. The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
• For best results, we recommend
replacing the batteries that came
with this toy with three, new “C” (LR14)
alkaline batteries.
• Locate the battery compartment on
the bottom of the toy.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door. Remove and
throw away all three batteries.
• Insert three “C” (LR14) alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• When sounds, lights or motions from this toy become faint or stop, it’s time for an
adult to change the batteries.
TILT SWITCH
When you pick up Toby, he stops
moving. Place him back on a level
surface to resume movement.
BATTERY
COMPARTMENT DOOR
• Protect the environment by not disposing of this product with house-
hold waste (2002/96/EC). Check your local authority for recycling advice
and facilities (Europe only).

• Wipe this toy with a clean damp cloth dampened with a mild soap and
water solution.
• Do not immerse this toy.
PRINTED IN CHINA K7926pr-0920
Let the learning fun begin! Care
Visit us on-line at www.service.fisher-price.com.
Call our Consumer Relations Department, toll-free at 1-800-432-5437, 9 AM - 7 PM
EST Monday through Friday and 11 AM - 7 PM EST Saturday. Hearing-impaired
consumers using TTY/TDD equipment, please call 1-800-382-7470.
Write to us at: Fisher-Price®Consumer Relations, 636 Girard Avenue, East Aurora,
New York 14052.
Consumer Information
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd.,Mississauga, Ontario L5R 3W2;
www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303;
www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2006 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
(United States Only)
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
FCC Statement
Letters
Press the button to learn the
alphabet. Each time you press,
Toby says the letter and displays it
on his screen.
Numbers
Press the button to learn
numbers. Each time you press,
Toby says the number and
displays it on his screen.
Shapes
Press the button to learn shapes.
Each time you press, Toby says the
name of a shape and displays it on his
screen. There are six shapes in all.
Music
Press the button to hear Toby
sing along with fun, flashing lights.
Press again to hear another song.
There are three songs in all.
POWER/VOLUME
SWITCH
Hi! I’m
Toby the
Totbot.
Let’s Play!
This little learning friend teaches fundamentals like the alphabet, numbers, and
shapes—all with endearing charm and plenty of singing and dancing! Toddlers will
discover just how much fun learning can be with Toby’s friendly voice, light-up display
screen, interactive music, and lots of fun movement.
• Locate the power/volume switch on Toby’s foot.
• Slide the switch to the desired position: on with low volume ; or on with
high volume .
• When your child is finished playing with this toy, slide the power/volume switch
off O.
Hints:
• If your child does not press any of Toby’s buttons for a while, Toby says “bye
bye” and turns off automatically (sleep mode).
• Static electricity that comes in contact with this toy may temporarily stop its
electronic function. A static electric charge can be created simply by walking
across a carpet or rug and then touching this toy. To reset the toy, either: Slide
the power/volume switch to the off position and then back to the on position
again; or Remove the batteries from the toy and reinstall the same batteries.
Your little learning friend!