Sontax 12590 User manual
*Actual product may vary slightly
Please carefully read and save these instructions before attempting to assemble, maintain, install, or operate this product.
Observe all safety information to protect yourself and others. Failure to observe the instructions may result in property
damage and/or personal injury. Please keep instructions for future reference.
For warranty purchases, please keep your dated proof of purchase. File or attach to the manual for safe keeping.
For Customer Service, Call 1-800-348-5004
This product contains or, when used, produces a chemical
known to the State of California to cause cancer and birth
defects or other reproductive harm.
(California Health & Safety Code § 25249.5, et seq.)
WARNING
LASER LIGHT PROJECTOR
LOCATION OF CONTROLS
USING THE LASER LIGHT PROJECTOR
1. Front lens
2. Laser lights
3. Thumbscrew
4. [POWER] button
FIXED LIGHT MODEL:
1. RED+GREEN Light
2. RED+GREEN Light Flash
3. GREEN Light
4. RED Light
HELPFUL TIPS
• After it is plugged in, the Laser Light Projector may need up to 30 minutes to achieve full brightness.
• Do not at any time shine the Laser Light Projector directly into anyone’s eyes or your own.
• Do not place the laser in such a position that it will shine into cars or low flying aircraft.
• At no point should you shine the laser directly into anyone’s eyes.
• When operating this device in unsupervised, accessible areas, it is recommended that direct access to
the Laser Light Projector is restricted or prevented.
• Do not stare into the laser light source.
• Do not shine the laser into any moving vehicles or low flying aircraft.
• Do not attempt to disassemble the Laser Light Projector as there are no user-serviceable components.
SAFETY INFORMATION
5. Fastener
6. AC Adaptor
7. Base
8. Base adaptor
• Do not attach your Laser Light Projector to a dimmer at any time as this may damage the laser itself.
• Unplug when not in use.
• Store in a cool dry place when not in use.
• Read and follow all instructions on the product and /or provided with the product.
• Before using or reusing, inspect the product carefully. Do not use the Laser Light Projector if there are any
cracks in the lens or the housing, cuts or frayed areas in the power supply cord or connection of the cord to
the plug, broken plug blades or any other damage that could be deemed a safety hazard.
• Do not directly cover the Laser Light Projector with cloth, paper, or any material not part of the product.
This could prevent heat dissipation or be a fire hazard.
• Do not hang ornaments or other objects from the cord or the Laser Light Projector.
• Do not mount or place near gas or electric heaters, fireplaces, candles or other similar heat sources.
• Keep away from children and pets.
DANGER: Do not intentionally shine into eyes or face.
LEGAL INFORMATION
READ AND KEEP THESE INSTRUCTIONS.
CAUTION: Any changes or modifications not expressly approved could void the user’s authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
WARNING: Lasers should not be projected at or within the
flight path of an aircraft within 10 nautical miles from an
airport. If your intended surface is within 10 nautical miles
of an airport, lower the angle of the laser light projector
so that no lasers point into the sky.
CAUTION: Do not use the Laser Light Projector in any
matter other than that intended by the manufacturer to avoid
exposure to hazardous laser radiation.
Do not attempt to open the Laser Light Projector under
any circumstance.
650
Max output <5mw
WAVE LENGTH 532-650nm
Class IIIa Laser Product
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
Limited Manufacturer Warranty
FOT makes every effort to ensure that this product meets high quality and durability
standards. FOT warrants to the original retail consumer a 1-year limited warranty
from the date the product was purchased at retail and each product is free from
defects in materials. Warranty does not apply to defects due directly or indirectly
to misuse, abuse, negligence or accidents, repairs or alterations, or a lack of
maintenance. FOT shall in no event be liable for death, injuries to persons or
property, or for incidental, special or consequential damages arising from the
use of our products. To receive service under warranty, the original manufacturer
part must be returned for examination by an authorized service center. Shipping
and handling charges may apply. If a defect is found, FOT will either repair or
replace the product at its discretion.
DO NOT RETURN TO STORE
For Customer Service:
Table of contents
