Sound Town OBERON-12SPW User manual

2022 SOUNDTOWN // Features and specifications are subject to change and or improvement without notice.
OBERON-12SPW
12" Powered Subwoofer
PRODUCT MANUAL EN

The SOUND TOWN poweredOBERON-12SPW subwoofer has a built-in high efficient
Class-D amplifier provide various of input connector such as 1/4" / XLR combo and
RCA.
Passthrough XLR line output provides the flexibility of connecting other apparatus.
LPF (Low Pass Filter) allows to adjust the frequency filter from 40~150Hz.
Baltic birch plywood cabinet with texture coated finish and metal grill holds up to
touring applications.
IMPORTANT SAFETY INSTRUCTIONS
1. Read all safety and operating instructions before using this product.
2. All safety and operating instructions should be kept for future reference.
3. Read and understand all warnings listed on the operating instructions.
4. Follow all operating instructions to operate this product.
5. This product should not be used near water, i.e. Bathtub, sink, swimming pool, web basement etc.
6. Only use dry cloth to clean this product.
7. Do not block any ventilation openings, it should not be placed flat against a wall or placed in a built-in
enclosure that will impede the flow of cooling air.
8. Do not install this product near any heat sources, such as, radiators, heat registers, stove or other apparatus
(including heat producing amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The side
blade or the third prong are provided for your safety if the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10. Protect the power cord being walked on or pinched particularly at Plugs, convenience receptacles and the
point where they exit from the apparatus. Do not break the ground pin of the power supply cord.
11. Only use attachments specified by the manufacturer.
12. Use only the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus.
When a cart is used use caution when moving cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation
ports or any other openings.
15. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way; such as, power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been
dropped.
16. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
17. When the MAINS plug, or an appliance coupler is used as the disconnect device, the disconnect device should
remain readily operable.
18. Protective Ground Terminal: The apparatus shall be connected to an AC main socket with a protective earth
ground connection.
FEATURES
In the package
1sOBERON ubwoofer
1 Power cable
1 User Manual
1 Warranty Card
How can we help you?
CONTACT OUR US-BASED SUPPORT TEAM
Simple or complex, your questions are important to us. For service, support
or more information, please contact the Sound Town support team:
Email: [email protected]

Rear Panel Instruction
7
1. Combo Input: Two balanced 1/4"/XLR combo jack A/B are provided. This allows for stereo input
from two separate feeds. The subwoofer will work with only one input connected.
Two XLR full-range passthrough output are provided. These outputs are not affected2. XLR Output:
by the LPF and will send full-range signal on the rest of your PA setup.
Two RCA unbalanced input are provided. The subwoofer will work with only one input3. RCA Input:
connected.
:4. Volume Control This controls the gain of the input signal. It will raise and lower volume of the
subwoofer. Standard usage is setting this control at 50%.
5:. LPF Control Low Pass Filter, this controls how much high frequency is filtered out of the signal
and how much of the higher bass frequencies are left in the signal. This does not add bass to the
signal, it determines how much high frequency is cut out of the signal. Setting this control to the
middle usually works best.
This control will reverse the phase of the speaker in relation to the rest of the PA. This6. Polarity:
allows a quick fix for an out-of-phase setup.
This indicator will light when the subwoofer is turned on.7. Power LED:
This indicator will flash when there is signal input.8. Signal LED:
This indicator lights up when the amplifier is near clipping. An occasional flickering is9. Clip LED:
acceptable. If LED is lit continuously, adjust the level control and reduce the output level of connected
sources. Failure to do so may lead to premature failure of your speaker.
On/Off10. Front LED control:
11. :IEC input This receptacle is for connecting the included IEC power cable. It is important to supply
the proper AC line voltage to the unit. Do not connect to intermittent or faulty power.
To turn on/off the subwoofer.12. Power Switch:
13. :Voltage selection This switch is supplied for moving the unit from 115 voltage (US Standard) to
230 voltage (European Standard). The switch needs to be set on the proper voltage for your area.
1
2
3
4
5
810
12 11 13