Sparehand Systems TF-401 User manual

Please check our website for instruction manual updates
© Sparehand Systems, 2018. All rights reserved. Made in China
SPAREHAND
®
Paddlesports
4 SUP storage system
Model: TF-401
v1.1
Caution – Failure to follow these guidelines can result in
property damage or personal injury.
 Parts are not labeled. Before assembly, please identify each part according to the
descriptions and diagrams below.
 Do not use if the product or any part is defective.
 Do not tilt or lift the storage rack.
 Do not drop SUP or any object on the rack. Place objects carefully and slowly.
 Do not step, stand, or climb on the storage unit.
 Do not use if loads are not balanced and / or cannot be used on level and secure ground. Always
make sure the rack will not tip over. Secure the rack to wall or floor if necessary.
 Always make sure heavier loads are at the bottom and never place your kayak on upper rack
position with the bottom rack empty. Top-heavy loads are dangerous.
 Use only if you determine the rack can be used safely.
 The manufacture and its agents are not responsible for any damages or injuries caused
by the use or misuse of the product.
 This rack is intended for indoor use. This rack may also be used outdoors under certain weather
and climate conditions with proper care and protection only. Use of this rack outdoors will
shorten the usable life of this rack.
 Please follow the instructions and observe weight and size limits. 40 Lbs and 14 feet
length maximum load per tier. Load and size limits are per pair of cradles. Maximum
Total Load: 200 lbs.
 When moving the storage rack, remove all objects from the rack.
 Warranty: 1 year Limited Manufacturer’s Warranty.
 For technical support or questions regarding this product, please contact
626-338-8998. PST 9:00 AM to 3:00 PM.
SPAREHAND
®
Systems, USA
Tel: [phone]
www.SparehandSystems.com [e-mail]
This product may be used for SUP, Paddleboard, Surfboard,
Longboard, Sailboard, Windsurfing board, and other similar devices.

Parts List
.
The following parts are required for TF-401
A. Base (2 PCS)
B. Cross Beam (2 PCS)
C. Vertical Post (2 PCS)
D. Cradle arm (8 PCS)
Hardware:
X Y
Long Short Cushion Pad
Tightening key
(20 PCS) (4 PCS) (8 PCS)
Installation Procedure: .
Step 1.
Assemble Part (A) onto Part (B) using bolt (X).
Step 2.
Assemble Part (C) to Part (A) using bolt (Y).
Step 3.
Connect part (B) on to part (C) with bolt (X).
Step 4.
Insert Part (D) to Part (C) with bolt (X). Adjust height and spacing.
Step 5.
Install cushion pad on Part (D).
Please use additional protection pads as necessary to protect your products.
Make sure all nuts and bolts are tightened
** Caster Wheels (part number C-4) sold separately, can be installed on this system.
Step 2
Y
A
A
B
Step 4
X
B
C
D
D
Step 1
X
Step 2
Y
C
Step 5