Speakman SA-2703 User manual

INSTRUCTIONS FOR MODELS
92-SA-2703-01
For additional assistance or service please contact:
SPEAKMAN®
800-537-2107
customerser[email protected]
www.speakman.com
SA-2703 TOWEL RING
TOOLS AND SUPPLIES
Phillips
Screwdriver
Pencil
Drill Drill Bit
Ø3/16”
Level
2.5mm Hex
Key (included)
Phillips
Drive Bit
Warranty information can be found at:
www.speakman.com
WARRANTY
MAINTENANCE
Cover the drain to prevent any loss of parts. Be sure
to wear eye protection while assembling the product.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives on any of the Speakman custom
finish products may damage the finish and void the
product warranty. Please be sure to only use approved
cleaners. Please contact Speakman for any clarification
of acceptable cleaners.
1If the Mounting Plate (1) comes pre-installed in
the Accessory (2), remove the Mounting Plate
by loosening, but not removing the pre-installed
Set Screw at bottom with the included 2.5mm
Hex Key (3).
2At the selected height, mark center point of
mounting locations onto wall referencing
the rough-in diagram.
3Align Mounting Plate over center point marked
in previous step. Mounting Plate should be
vertical as shown below. Mark Mounting Screw
locations onto the wall surface. Remove item(s)
after marking mounting locations.
4If mounting directly to wood stud, Plastic Anchors
are not required. If mounting to tile, acquire
proper mounting hardware capable of supporting
the accessory in use. If mounting to drywall, drill
guide holes at marked locations using a Drill
equipped with a Ø3/16" bit.
Ø3 /16”
5Insert Plastic Anchors into drilled holes and screw
in the Anchor using a Phillips Head Screwdriver,
or a Drill equipped with a Phillips Driver Bit until
the head is flush with the wall surface.
OR
6Secure Mounting Plate (1) with the Mounting
Screws (2) provided. Verify that the Mounting
Plate is aligned vertically.

7Place Accessory (1) over Mounting Bracket (2)
and secure it by tightening the pre-installed Set
Screw with the included 2.5mm Hex Key (3).
SA-2703 REPAIR PARTS
RPG05-104020 MOUNTING HARDWARE REPAIR GROUP
ITEM NO. PART NO. DESCRIPTION
SA-2703 ROUGH-IN DIAGRAM SPEAKMAN®
DIMENSIONS SUBJECT TO CHANGE WITHOUT NOTICE.
NOTES:
COMPLIANCE:
CONNECTIONS:
Finishes Meet: ASME A112.18.1
CSA B125.1
• Includes All Necessary Mounting
Hardware.
23
16
"
56mm
11
16
"
27mm
15
8
"
41mm
79
16
"
193mm
7
16
"
11mm
3
8
"
10mm
611
16
"
171mm