Spinner BN 666000 User manual

Data subject to change without notice –26.09.2022
SPINNER GmbH │ Erzgiessereistr. 33 │ 80335 München │ Germany │ www.spinner-group.com │ [e-mail]
Installation guide for antenna
BN 666000
1 Introduction and safety advice
This instruction shall provide information how to install the antenna with mounting kits.
All shown tasks are intended to be carried out by qualified personnel only. Safety rules apply (e.g.
for working with heavy loads, radio frequency power signals or tools). In order to prevent damage
to equipment and humans, make sure that no RF power is present at the combiner during
installation.
Please note that satisfactory performance of the system (especially in terms of intermodulation)
can only be achieved if all jumper cables and connectors are handled properly. Please make sure
that all connectors are clean and free from metal dust or dirt. Avoid sharp bending of the
connecting jumper cables.
After carrying out all described steps, the antenna is ready for use. Make sure that the specified
environmental conditions for operation are not exceeded.
SPINNER does not guarantee for any faults or damage resulting from improper installation.

Data subject to change without notice –26.09.2022
SPINNER GmbH │ Erzgiessereistr. 33 │ 80335 München │ Germany │ www.spinner-group.com │ [e-mail]
2 Installation
2.1 Install the antenna:
Method 1: Mast or pole mounting
Step 1: First attach the stainless steel hose clamps to the antenna mounting plate.
Step 2: Use the stainless steel hose clamps to secure it to the pole and tighten the
screws.
2.2 Install the antenna:
Method 2: On wall mounting
Step 1: Drill 3 holes (M6*25) in the designated position on the wall.
Step 2: Put the plastic dowels into the holes.
Step 3: Tighten the antenna with self-tapping screws (M4*25) to the wall.