SportsPlay Equipment 551-110 User manual

551-110 Baseball Backstop
Page 1
Rev 05/22/08
IMPORTANT
PLEASE READ THESE INSTRUCTIONS BEFORE COMMENCING ASSEMBLY. All equipment
must be installed in accordance with these instructions. Check your shipment
against Bill of Lading and Parts list. Any missing or broken parts must be
reported to your distributor within 10 days of receipt of your order. When
properly installed and maintained, equipment will give many years of Safe,
Trouble-Free use. Periodically check for loose or broken parts. Loose bolts
must be tightened and broken parts must be replaced as they can possibly
create dangerous situations leading to unnecessary accidents.
PACKING LIST HARDWARE BAG
1 CTN 1 Hardware Bag 2 105-017 2 3/8” Pipe Plugs
2 PANEL 1 553-351 Panel 4 pr 555-511 1” x 1” Saddle Clamp
2 PIPE 1 553-602 2 3/8” OD x 13’ 8 pr 555-512 1” x 2 3/8” Saddle Clamp
16 126-505 5/16” x 1 ¼” Carriage Bolt
4 116-504 5/16” x 1” Hex Bolt
20 326-501 5/16” Lock Washer
20 216-501 5/16” Hex Nut
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 [phone]
1 CTN 2 PIPE 2 PANEL 5 TOTAL PCS 195# Weight Class 70

551-110 Baseball Backstop
Page 2
Rev 05/22/08
GENERAL ASSEMBLY INSTRUCTIONS:
1. Check each piece carefully and remove any sharp projections that may
have been caused by shipping.
2. DO NOT Tighten nuts more than hand tight until entire assembly is
completed.
3. All Threaded ends of bolts protruding beyond nuts should be cut off and
peened over to remove any sharp edge.
SPECIFIC ASSEMBLY INSTRUCTIONS:
1. Layout and dig holes
2. Assemble backstop on ground with bottom of upright posts at front edge
of holes. Tighten all bolts securely.
3. Raise and lower assembly into holes.
4. Plumb and Level backstop.
5. Pour footings. Approximate concrete required – 4.7 cubic feet.
MAINTENANCE INSTRUCTIONS:
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 [phone]
Check periodically for loose bolts, broken parts and replace immediately.