SportsPlay 601-695S User manual

10’ Standard Bench without Back For Part Numbers: 601-695S,
601-695I, 601-695P
Component Details
Item No.
Part Number
Description
QTY
1
613-514BP
Bench Plank
2
2
*Frame Index
Bench Leg
3
3
126-704
3/8 x 1 ¼” Button Head Bolt
6
4
316-601
3/8 Washer
8
5
416-505
7/32 Allen
1
6
226-602
3/8” Nylon Locknut
2
Additional Components for Portable Frame
7*
613-614
Portable Brace*
2
8*
126-701
3/8 x 1 ¼” Button Head Bolt
1
9*
316-601
3/8” Washer
6
10*
126-602
3/8” Nylon Lock Nut
3
12*
126-704
3/8 x 3” Button head bolt
2
Additional Components for Surface Mount
11**
531-062
3/8 Concrete Anchor
8
08/27/2020
www.sportsplayinc.com
1
Detail B
4
2
3
1
*Only required on units that have a portable frame.
**Only Required on Surface on units that have a surface mount
frame
Note: Refer to the frame index and style index for part identification and
component specific instructions.
1
Detail C

10’ Standard Bench without Back For Part Numbers: 601-695S,
601-695I, and 601-695P
Important
Please keep a copy of these instructions in your files. There is
important replacement part information in them that will assist
you in the event a part is ever needed.
Assembly Information
Read all assembly instruction before starting assembly.
Verify that all parts were received by comparing the parts
received to the component list on page one.
If your product mounts to something (surface mount, in ground
or wall mount) you will assemble the entire product before
drilling holes or mounting frame in order to ensure proper
layout.
CONTACT YOUR DISTRIBUTOR ABOUT ANY PARTS YOU ARE
MISSING. You must report missing parts within 10 days of
delivery.
Hand-tighten all bolts during the initial assembly (unless
specifically told to tighten completely in the instructions). Once
the unit is fully assembled and square you should completely
tighten them.
Other than when a specific step in the assembly instructions
specifies “to not apply LocTite, we recommend applying a small
amount to all assembly bolts.
General Maintenance
It is recommended that you inspect the product monthly for
loose bolts and broken parts. If replacement parts are needed
please refer to these instructions for part numbers and
descriptions then call your distributor to order replacements.
Assembly Instructions
NOTE: Only assembly your bench at this time. After it is assembled
you may refer to the frame index so you can identify your frame type
and then locate the specific mounting instructions for that frame.
1. Attach one end of the Bench Planks (1) to one of the Bench
Legs (2) by inserting two 3/8” x 1 ¼” Button Head Bolts (3) and
3/8” Washers (4) through the bottom of the leg and into the
factory installed nuts on the mounting plate attached to the
bottom of the bench plank (Detail B)
2. Next place the center leg between the two bench planks and
insert the (2) 3/8” x 1 ¼” Button Head Bolts with (4) 3/8” Washers
through one bench plank, center leg tab, and second bench plate.
Install washers and (2) 3/8” locknuts on back side and tighten
(Detail C)
3. Now identify your frame type from and follow the specific
instructions for your frame. Again, use the frame index page to
complete this step.
08/27/2020
www.sportsplayinc.com
2