St George LWG74A*-3050 User manual

139981
CPW206
FFhamF pzF ©4dF
Regular Cycle
Use for sturdy items, like play or work clothes,
towels, T-shirts, etc. The wash time selection will
depend on the type of fabric and the amount of soil.
For the best results when cleaning heavily soiled
items, use a longer wash time (15 minutes
maximum). Lightly soiled items require less wash
time.
Permanent Press/Knits Cycle
Use for permanent press items and synthetics. The
wash time selection will depend upon the type of
fabric and amount of soil.
The PERMANENT PRESS/KNITS cycle
automatically cools the temperature of the fibres
before the spin. After the wash, the agitation stops,
the washtub spins slowly, partially drains and then
stops. Cold water will then be automatically added
to the washtub until the proper water level is
reached. This happens one or two times, depending
on the size of the load and type of drain connection.
When the COOL DOWN is complete, the washer
will pause shortly before continuing the cycle.
Soak/Prewash (With Options Switch OFF)
Use for heavily soiled or stained clothing. Turn
timer knob to the beginning of the SOAK/
PREWASH cycle. Pull timer knob out to start the
water fill. Add detergent to the washtub, then place
the load into the tub. Close lid. After fill is
completed, agitation will begin. This cycle has
alternateperiods ofagitation and soaking.After the
soak/agitation periodis over the washer will gointo
an infinite pause and remain there. Do not leave
clothes sit in washer overnight. To complete the
cycle, manually advance the timer to spin. After
spin, select appropriate cycle and pull timer out to
start the water fill. Once the water mixes with the
clothes, add detergent.
Soak/Prewash (Using the Options Switch)
See Options on following page.
Delicate/Woollens Cycle
Use this cycle to wash delicates and machine
washable woollens. A full tub of water is
recommended (even for small loads) to allow the
delicate items to move freely through the water.
More water helps reduce fabric wear, wrinkling,
and provides for a clean wash. Both wash and spin
actions are at slow speed.
Super Wash
Use this cycle for very heavily soiled or stained
clothing. This cycle will go through the Soak/
Prewash, Regular and Extra Rinse cycles. The
option switch must beon Super Wash for this cycle.
Extra Rinse
Use this cycle for items you would like to have
rinsed only. The washtub will fill to the level you
have selected on the LOAD SIZE control. Washer
will agitate for fiveminutes, pause shortly and spin.
To reduce the risk of fire, electric
shock, serious injury or death to
persons, read the IMPORTANT
SAFETY INSTRUCTIONS in the Use
and Care Guide before operating
your washer. W018E
WARNING
Model Number LWG74A*-3050
zF"amV m¤4apm
© Copyright 1999, Alliance Laundry Systems LLC Part No. 39981
August 1999

239981
W395IE0A
p "^ dp^F
IMPORTANT: Before using your new washer,
make sure the washer cord is plugged into a
240 Volt electrical outlet that has the proper
earthing and polarity. Make sure the washer
hoses are connected to the hot and cold water
taps, and that the taps are turned on. Be sure the
drain hose is not kinked and is inserted into a
drain. See the INSTALLATION
INSTRUCTIONS for details of proper washer
installation.
IMPORTANT: Prior to first wash, use an all
purpose cleaner or a detergent and water
solution and a damp cloth to remove shipping
dust from inside of washtub.
1. Get the clothes ready for
washing. Empty pockets and
cuffs. Sort items into
separate loads. Pretreat
stains and heavily soiled
areas.
2. Measure and add detergent
to the washtub.
3. Add clothes loosely into the
washtub.
4. Close the loading door.
5. Set WASH/RINSE temperatures.
NOTE: The washer will
provide a cold rinse in all
TEMPERATURE settings
except in positions marked
HOT wash WARM rinse or
WARMwashWARMrinse.
DO NOT use a warm rinse
with permanent press or
other synthetic fabrics. A
warm rinse can cause
wrinkling in some garments. Cold rinses will
save you money and energy and will helpreduce
wrinkling in permanent press and synthetics.
The Energy Saver settings, marked with a
dot (•), show which temperature settings will
use the least energy.
6. Set LOAD SIZE
(WATER LEVEL)
control. Use RESET if
agitation has started and
more water is needed.
IMPORTANT: Holding the LOAD SIZE
(WATER LEVEL) control in the RESET
position can cause flooding of the washer.
7. Select the cycle according to the type of fabric
being washed. Push the timer knob in and turn
clockwise to the desired cycle and wash time.
8. Pull the timer knob out to start the water fill.
Agitation willbeginwhen the water reaches the
level you selected.
The washer will stop (pause) shortly before the
wash and rinse spins. Do not turn the timer
through these pauses. They are part of the cycle.
zapm
Prewash
Use for heavily soiled orstained clothing.Whenthe
PREWASH setting is selected, the washer will
automatically go through the SOAK/PREWASH
and the REGULAR cycle. First, add detergent into
the wash tub, then place the wash load into the tub.
Fill softener dispenser in agitator with liquid
detergent diluted with water.
IMPORTANT: Dispenser must be cleaned
before and after using detergent.
Extra Rinse
Use for heavy clothing such as denim, towels, etc.,
where an additional deep rinse may be desired.
When the EXTRA RINSE setting is selected, the
washer will automatically go through the
REGULAR cycle and a second deep RINSE cycle.
D305IE1A
W281IE0B
W318IE0C

339981
Drip Dry
Use this setting for clothing you want to remove
from the washer very wet.In this setting the washer
will drain the water out but not spin.
If certain items need to be spun out, return the
OPTIONS switch to the OFF position and the cycle
will progress through the final spin. There is no
need to advance the timer knob.
Super Wash
Thissettingisacombinationof the PREWASH and
the EXTRA RINSE cycles. When the SUPER
WASH setting is selected, the washer will
automatically go through the SOAK/PREWASH,
REGULAR, and EXTRA RINSE cycles. First, add
detergent into the wash tub, then place the wash
load into the wash tub. Fill softener dispenser in
agitator with liquid detergent diluted with water.