Stage right SRD210 User manual

SRD210 10" Powered Speaker
P/N 600015
User's Manual

2
SAFETY WARNINGS AND GUIDELINES
Please read this entire manual before using this device, paying extra attention to these
safety warnings and guidelines. Please keep this manual in a safe place for future reference.
•This device is intended for indoor use only.
•Do not expose this device to water or moisture of any kind. Do not place drinks or
other containers with moisture on or near the device. If moisture does get in or on
the device, immediately remove it from its power source and allow it to fully dry
before reapplying power.
•Do not touch the device, the power cord, or any other connected cables with wet
hands.
•If operating this speaker in a humid environment, ensure that no condensation
occurs. Condensation could cause damage to the speaker cone and could cause a
short in the amplifier, which in turn could cause fire or severe electric shock.
•Do not install this device on an unstable surface where it could fall and cause either
personal injury or damage to the device and/or other equipment.
•Do not expose this device to excessive vibration, extreme force, shock, or
fluctuations in temperature or humidity.
•Do not expose this device to excessively high temperatures. Do not place it in, on,
or near a heat source, such as a fireplace, stove, radiator, etc. Do not leave it in
direct sunlight.
•Do not place or install this device in an area where it can be exposed to excessive
amounts of dust, humidity, oil, smoke, or combustible vapors.
•Prior to operation, check the unit and power cord for physical damage. Do not use if
physical damage has occurred.
•Before plugging the unit into a power outlet, ensure that the outlet provides the
same type and level of power required by the device.
•This device uses a grounded power cord and requires a ground connection for safe
operation. Ensure that the power source has a proper ground connection. Do not
modify the plug or use a "cheater" plug to bypass the ground connection.

3
•Disconnect the unit from the power source when replacing the fuse. Replace the
fuse only with the same type.
•Unplug this device from the power source when not in use.
•Take care to prevent damage to the power cord. Do not allow it to become
crimped, pinched, walked on, or become tangled with other cords. Ensure that the
power cord does not present a tripping hazard.
•Never unplug the unit by pulling on the power cord. Always grasp the connector
head or adapter body.
•Ensure that power is turned off and disconnected before making any electrical
connections.
•Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or
detergents. For stubborn deposits, moisten the cloth with warm water.
•This device has no user serviceable parts. Do not attempt to open, service, or
modify this device.
CUSTOMER SERVICE
The Monoprice Customer Service department is dedicated to ensuring that your ordering,
purchasing, and delivery experience is second to none. If you have any problem with your
order, please give us an opportunity to make it right. You can contact a Monoprice
Customer Service representative through the Live Chat link on our website
www.monoprice.com or via email at su[email protected]. Check the website for
support times and links.

4
PACKAGE CONTENTS
Please take an inventory of the package contents to ensure you have all the items listed
below. If anything is missing or damaged, please contact Monoprice Customer Service for a
replacement.
1x SRD210 10" Powered Speaker
1x AC Power Cord
1x User's Manual
PRODUCT OVERVIEW
1. SD: Slot for an SD™ card with mp3 files
for playback with the Digital Player.
2. USB: USB port for connecting a USB
flash drive with mp3 files for playback
with the Digital Player.
3. CONTROLS: Controls for the Digital
Player. Press the MODE button to
switch between USB, SD, and
Bluetooth® playback with the Digital
Player. The remaining buttons are
Previous Track, Next Track, Repeat, and
Play/Pause. The Repeat button cycles
through OFF (no repeat), ONE (current
track), RDO (random), and ALL (all
tracks).
4. OPERATING LEDS: The POWER LED
illuminates when the speaker is
powered on, the SIG LED illuminates
when an input signal is detected, and

5
the CLIP LED illuminates when clipping is detected. If clipping occurs, the volume
level should be reduced.
5. DSP MODE LEDS: One of the LEDs illuminates to indicate which DSP mode is in use.
6. MIC/LINE: Volume control for the MIC/LINE input.
7. LINE/MIC: Button to switch the MIC/LINE input sensitivity between line level and
microphone level.
8. MIC/LINE: Combination 1/4" / XLR input jack for input from a line level source or a
dynamic microphone.
9. GUITAR/MIC: Volume control for the GUITAR/MIC input.
10. GUITAR/MIC IN: 1/4" input jack for input from a guitar or dynamic microphone.
11. AUX/MP3: Volume control for the AUX input or the mp3 player.
12. AUX IN: Unbalanced stereo line input.
13. DSP PRESET: Rotate the knob to select the various DSP modes.
14. MIX OUT: Line level output for connecting another speaker.
15. 115V/230V: Voltage selector switch used to set the input voltage. The switch is
covered by a clear plastic plate to prevent it from being accidentally changed.
16. POWER: Switch for turning the speaker on or off.
17. AC INPUT: Combination IEC 60320 C14 power connector and fuse holder.
BLUETOOTH PAIRING
Perform the following steps to pair your mobile device with the Digital Player.
1. Press the MODE button to select BT mode. If a previously paired device is within
range, the speaker will connect to that device. Otherwise, the speaker will enter
Bluetooth® Pairing Mode.
2. Open the Bluetooth settings on your phone and scan for nearby Bluetooth devices.
3. Locate and select the SRD210 entry. If prompted for a passcode, enter 0000 (four
zeros).

6
4. The speaker and your mobile device will pair and connect.
SPECIFICATIONS
P/N
600015
Woofer Size
10"
Tweeter Size
1"
Input Power (RMS)
200 watts
Input Power (Maximum)
400 watts
Input Power (Peak)
800 watts
Nominal Impedance
4 ohms
Sensitivity
96dB
Bluetooth® Pairing Name
SRD210
Input Power
115 VAC, 60Hz or 230 VAC, 50Hz
Dimensions
14.6" x 13.8" x 22.0" (370 x 350 x 560 mm)
Weight
22.0 lbs. (10 kg)

7
TECHNICAL SUPPORT
Monoprice is pleased to provide free, live, online technical support to assist you with any
questions you may have about installation, setup, troubleshooting, or product
recommendations. If you ever need assistance with your new product, please come online
to talk to one of our friendly and knowledgeable Tech Support Associates. Technical
support is available through the online chat button on our website www.monoprice.com
or through email by sending a message to [e-mail]. Check the website for
support times and links.
To download the latest drivers, firmware, manuals, etc., go to www.monoprice.com and
type the P/N into the search bar. If available, support files are linked at the bottom of the
product page.
REGULATORY COMPLIANCE
Notice for FCC
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Modifying the equipment without Monoprice's authorization may result in the equipment
no longer complying with FCC requirements for Class B digital devices. In that event, your
right to use the equipment may be limited by FCC regulations, and you may be required to
correct any interference to radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio

8
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Notice for Industry Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Monoprice™, Stage Right™, the Stage Right logo, and all Monoprice logos are trademarks
of Monoprice Inc.
SD™ and the SD logo are trademarks of SD-3C, LLC.
The Bluetooth® word mark and logos are registered trademarks of Bluetooth SIG, Inc.