Starburst Technologies SB-3790ART-FM User manual

CONTACT:
a division of PDI Communications Inc.
6353 W Rogers Circle #6, Boca Raton, FL 33487
TF: 800-242-1606
Email: [email protected]
Web: www.starburstmounts.com
©2019 Starburst Technologies All rights reserved.
Installation Manual
Swivel Tilt Extend TV Wall Mount
Model: SB-3790ART-FM
Please visit our Starburst
Mounts YouTube channel
for installation videos.
If you have any question, please contact us at 800-242-1606, or send an email to [email protected].
CAUTION:
This mount is intended for use only
with a maximum weight of 132 lbs. Use with
products heavier than the maximum weight
indicated may result in collapse of the mount
and its accessories, causing possible injury.
ATTENTION: Ce support est conçu pour être utilisé
uniquement avec un poids maximal de 132 lb. L'utilisation
avec des produits plus lourds que les poids maximaux
indiqués peut entraîner l'affaissement de la monture et
de ses accessoires, pouvant entraîner des blessures.

• Use with products heavier than the rated weights indicated may result in instability
causing possible injury.
• Please closely follow the assembly instructions. Improper installation may result in
damage or serious personal injury.
• Safety gear and proper tools must be used.
• This product is designed to be installed on solid concrete walls or wood stud walls.
• Make sure that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
• Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
• This product contains small items that could be a choking hazard if swallowed. Keep
these items away from children.
• This product is intended for indoor use only. Using this product outdoors could lead
to product failure and personal injury.
• Save these instructions for future use.
IMPORTANT SAFETY INSTRUCTIONS
PREPARATION:
Please make sure the mount is appropriate for the TV before installation.
What’s your wall frame?
Wood stud walls Drywall alone
Solid concrete walls
√√ ×
3
Measure the hole pattern found on the back of your TV. If the horizontal distance is
400mm and the vertical distance is 300mm, the VESA size of your TV is 400x300.
Refer to the corresponding VESA size on the instruction manual. If the mount is not
compatible, contact your local Starburst dealer or visit starburstmounts.com to find
a right mount.
200x200/300x200/300x300
400x200/400x300/400x400/600x400
200x100/
Does your TV match the stated VESA?
2
Does the weight of TV (including accessories)
exceed the maximum weight limitation? 132lbs
(60kg)
RATED
132lbs
(60kg)
RATED
1
If the mount is not compatible, contact your local Starburst dealer
or visit starburstmounts.com to find a right mount.
Read the entire instruction manual before you start the installation and
assembly. If you have questions regarding any of the instructions or
warnings, please contact your local Starburst dealer for assistance.
Thank you for purchasing our Starburst SB-3790ART-FM mount. This SB-3790ART-FM
Swivel Tilt Extend TV wall mount extends an amazing 31.5" from the wall, providing
enough space for maintenance or wiring. Sits 2.8" from the wall when fully compressed.
Features +2°~-15° tilt adjustment and +60°~-60° swivel adjustment.
What tools are required for the installation?
4
Power Drill Phillips Screwdriver PencilTape Measure
Wood Stud Install
Φ 1/4 inch Drill Bit
Solid Concrete Install
Φ 1/2 inch Drill Bit
Tips：Tools are not included in the package.
Stud Finder Hammer
1
Bubble LevelSocket Wrench
(14mm)
1 /2 inch
1

Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, contact us for a replacement.
PACKAGE LIST
TV Bracket & Arm Assembly (x1)
A
Anchor
W-B (x6)
Lag Bolt
W-A (x6)
Allen Key (x1)
I
M8x30
M-G
(x4)
M6x30
M-F
(x4)
M5x14
M-C
(x4)
M4x14
M-A
(x4)
M8x50
M-H
(x4) Spacer (x8)
M-J
Spacer
M-K
(x8)
M4x35
M-B
(x4) M5x35
M-D
(x4) M6x14
M-E
(x4)
INSTALLATION
1. Remove TV Bracket from the Arm Assembly
Loosen and release the upper and lower hexagon nuts found on the back of center column of TV bracket with double
ended cresent wrench (H).
A
Flat Washer
W-C (x6)
Two-Hole Washer (x4)
M-I
Mounting Template (x1)
C
Cover (x2)
D
Fixing Piece (x2)
EM6x15 (x7)
F
Flat Washer (x7)
G
Double Ended
Cresent Wrench (x1)
H
Wall Plate (x1)
B
2. Attach the Bracket to TV
2.1 Place TV Bracket as Shown
2. Position the TV brackets as close as possible to the
center of the display.
2.2a Attach TV Bracket to Flat Back Screen
Attach TV bracket using the shorter TV screws
(M-C)/(M-E) and washers (M-I) .
(M-A)/
TV
1.2b Attach TV Bracket to Irregular (Curved or
Recessed) Back Screen
Attach TV bracket using the longer TV screws
(M-B)/(M-D)/(M-F)/ (M-G)/(M-H) ,washers (M-I)
and spacers (M-J)(M-K).
TV
M-E
M-I
M-K M-J
M-K
M-I M-I
M-B
M-D
M-F
M-G
M-J
M-I
M-K
M-H
M-I
M-J
M-K
M-H
M-I
M-J
M-K
M-H
M-I
Length:
A screw that is too long can damage the display.
A screw that is too short will not hold the display.
Select appropriate TV screws
TV TV
CAUTION 
TV TV
M4 M6 M8
Diameter:
Inserts the screws into the hole on the back of
your TV to determine which diameter to use.
M-A/M-C
M-I
M-B
M-D
M-F
M-G
M-B
M-D
M-F
M-G
H
A
A
B
With the arrow pointing up.
H
1. Loosen and release the upper and lower hexagon nuts
found on the back of TV arm brackets and adjust brackets
to align the hole pattern of your TV. Once adjusted, tighten
the all hexagon nuts .
B
B
32
Level (x1)
J

X X
√
3a. Attach Wall Plate to Wood Stud 3b. Attach Wall Plate to Concrete Wall
Note: Prior to installation, ensure the area behind the surface is free of electrical wiring, pipes, or other objects.
1.Verify the center of the studs using a stud finder.
3. Drill pilot holes to the depth of 3.5 inch using
diameter drill bit.
a 1/4 inch
W-A
W-C
X
W-A
W-C
W-B
3.5"3.5"
ø1 /4"
2. Level the template(C) and mark the hole
using pencil.
locations
Ensure alignment using a bubble level .(J)
CAUTION
4.Attach the wall plate using 4 lag bolts (W-A) and
washers (W-C) with Socket Wrench.
Make sure to drill into the CENTER of the stud.
CAUTION
Note: Prior to installation, ensure the area behind the surface is free of electrical wiring, pipes, or other objects.
X X
√
2. Drill pilot holes to the depth of 3.7 inch using
diameter drill bit.
a 1/2 inch
3. Insert anchors with hammer then
plate using 6 lag bolts (W-A) and washers (W-C) with
Socket Wrench.
(W-B) attach the wall
3.7"3.7"
ø1 /2"
2. Level the template(C) and mark the hole
using pencil.
locations
Ensure alignment using a bubble level .(J)
CAUTION
Never drill into the mortar between blocks.
CAUTION
Be sure the anchors are flush with the surface.
CAUTION
C
C
B
B
54
J
J

Attach TV bracket to the arm assembly by tightening the
4 hex nuts with double ended cresent wrench (H).
4. Attach Arm Assembly to Wall Plate 5. Hang the TV
1.Hold the arm assembly with the top tilted toward the wall,
and then slide the arm assembly over the upper lip of the
wall plate (B) left or right to remain centered.
2.Insert two fixing pieces (E) into the upper and lower slots
of the wall plate(B). Make sure the mounting holes on the
arm assembly completely align with the screw holes on
the fixing piece and wall plate.
Secure the arm assembly with 7 hex socket flat head
screws (F) and washers (G) using Allen Key (I).
3.Attach the decorative covers (D) to the wall plate.
Heavy! You will need assistance with this step.
6. Cable Management
EGF
I
H
Pull each arm to its full extension then route the cables
through the arms, leaving enough slack to prevent
stretching the cables when the arms are moved.
D
or
76

The Warranty Period:
Starburst Technologies warrants the products to be free of defects in material and workmanship for the warranty
period of 5 years. The Warranty Period commences on the original purchase date of the product.
To Get Warranty Service:
For warranty claims made during the above Warranty Periods, Starburst will replace (or credit the amount of)
any defective product part free of charge. Should a part on your Starburst product fail, contact Starburst to make
a warranty claim. We will discuss the problem with you and once we confirm the product is under warranty, we
will ship replacement parts to you or issue credit based on the amount.
WARRANTY
To the maximum extent permitted by applicable law, Starburst disclaims any other warranties, express or implied,
including warranties of fitness for a particular purpose and warranties of merchantability. Starburst will not be
liable for any damages whatsoever arising out of the use or inability to use its products, even if Starburst has
been advised of the possibility of such damages. To the maximum extent permitted by applicable law, Starburst
disclaims any responsibility for incidental or consequential damages including damage caused to electronic
equipment or to the surroundings by the use of the product.
• The installation of other products to the mount / shelf not manufactured by Starburst.
• Product is modified in any way, improperly installed or taxed beyond its stated weight capacity or otherwise
misused or abused.
• Normal wear and tear, friction damages, breakage of plastic and glass, spring wearing, coating defects, or the
impact of using a product in an outdoor environment.
• Losses or damage due to fire, theft, vandalism, modifications, repairs, accidents, force majeure.
• The Warranty for wall and ceiling mounts is void if the mount is moved from its initial installation.
• This Warranty does not cover the costs of removing and replacing defective parts from your Starburst product.
So, if your problem requires a repair technician, you must pay any labor charges.
• Should a replacement part or product be discontinued or unavailable, Starburst reserves the right to substitute
a comparable replacement part or product for the defective part or product.
The Warranty extends only to the original purchaser, and it does not apply to:
5 5
WARRANTY
YEARS
1. Disconnect cables and turn off the power.
2. Loosen and release the upper and lower hexagon nuts
found on the back of center column of TV bracket. A
3. Carefully lift the TV from arm assembly.
7. Adjustment
8. Remove the TV
Heavy! You will need assistance with this step.
Extend & Retract Level Adjustment
Tilt Adjustment Swivel Adjustment
MAINTENANCE: Check that the product is secure and safe to use at regular intervals (at least every three months).
H
+2°
-15°
+3° -3°
±60°
Lock
Unlock
98
A
A