STARVILLE MATRIXX TLB-20 DMX User manual

User Manual
Please read this Manual assiduous before start working
with the effect light!!!

2
Packing List
1 pcs. Stairville maTRIXX TLB-20 DMX
1 pcs. Power cord
1 pcs. Owners manual
2 pcs. Lighting Hangers
Product Introduction：
This product adopts the latest appearance, with small volume, light
heaviness, nice appearance and good heat scattering. The luminary
constitutes of 64 LED light pearls with high brightness, long life and low
power consumption. It has applied latest software controlling technology
with effect such as 85 pictures, level and erecting moving, level and
erecting turning, enlarging and shrinking, gradually drawing, stroboscopic,
brightness regulation, etc. 26 different effects have been set inside. DMX
control has adopted page control (music control page, automatic control
page), the effect will be edited according to the actual music while without
music the light will be switched off after the delay. It has four control
modes: automatic control, DMX-512 control, music control and master&
slave synchronization control. The international standard DMX-512 signal
control makes the difference between our products and others.
Instruction：
After unpacking, please check whether the projector has been damaged
by transport such as screw loosening, reflecting mirror broken, etc.
Check before electrification. Check whether the projector has been laid
correctly and stably, whether the voltage of the power is adapted to the
requirement, otherwise we’ll not be responsible for the damage of the
light.
This projector is the first class protected equipment. Notice that while
using the green and yellow wires have to connect to the ground properly
by professionals. Please examine the electrics and voltage before
powering on it. We suggest customers apply 220V or a transformer. It’ll
check itself in seconds after being electrified, could be used.

3
Technical Parameters:
Rated voltage: AC110V /230V ±10%
Rated frequency: 50Hz〜60Hz±10％
Power consumption: 20W
Beads quantity: 192 super bright light pearls (red: 72pcs,
green: 72pcs, blue: 48pcs)
Pictures quantity: 85
Channels: 10 channels
Control signal: DMX-512 international standard signal
Control mode: DMX-512、automatic、music、master & slave
Operating environment: indoor
Function Mode Set:
This unit apply to Switch-address code, which is the choice of the mode of the
performing control and the address-code, the 10th address-code is the switch
of the transferring of the DMX-512 signal control , music control and automatic
control. The mode set, details as following:
Mode
Binary code（ON）
1
DMX-512signal control mode
1-9 setting address, 10--on
2
Single music control, master
1--ON、2-10--OFF
3
automatic ,master
9 ON, all others OFF
4
Slave control
1-9—NO SETTING、10--ON

4
DMX-512 Function:
CHANNEL
DMX-512 VALUE
CONTROL
CH1
Automatic control
0〜41
LED light switch off
42〜83
Effect Editing Control
84〜125
Insetting Effect Control
126〜167
Run insetting program
Music control
168〜209
Effect Edition Control
210〜251
Insetting Effect Control
252〜255
Run insetting program
CH2
Pictures choice
0〜255
85 pictures selection
Effect choice
0〜255
26 effects selection
CH3
Erect turning
0〜127
Position selection
128〜255
Speed Selection
CH4
Level turning
0〜127
Position Selection
128〜255
Speed Selection
CH5
Erect Turning
0〜85
Speed Selection
Level turning
86〜171
Level, Erect turning
172〜255
CH6
From Small to Big
0〜85
Speed Selection
From Big to Small
86〜171
Shrink or Enlarge
172〜255
CH7
E r e c t G r a d u a l l y
drawing
0〜85
Speed Selection
Level Gradually
Drawing
86〜171
Level, Erect
gradually drawing
172〜255
CH8
Stroboscopic Effect
0〜255
Speed Selection from slowest to
fast
CH9
Brightness
Regulation
0〜255
Selection From Brightest to dark
CH10
Shinning beads
Selection
0〜255
Shinning beads selection

5
Signal Connection
This product is assembled with DMX input and output 3 pins XLR socket,
while all connection is that Pin 1 is connected to the ground, Pin 2 is
connected the negative pole signal, Pin 3 is connected the Positive pole
signal. This product applies 3 pins XLR socket, the connection of many
units as following:
NOTICE:
1. No overloading connection, the same branch without over 32
2. Terminal matching connection, connect a resistance of1 20 ohms between
the Foot 2 and Foot 3 of DMX output Pin 3 socket of the last
equipment of the branch.

6
DMX-512 address code set:
This unit is equipped with 10 channels, while the address code of the first
light is 1, the second 10+1=11, the third 10+11=21, and so on.
Detailed DMX-512 address code set as following:
Light NO.
Original address
Binary Code Dialing（ON）
1
1
1
2
10
2、4
3
19
1、2、5
4
28
3、4、5
5
37
1、3、6
6
46
2、3、4、6
7
55
1、2、3、5、6
8
64
7
9
73
1、4、7
10
82
2、5、7
┇
┇
┇
Notice about Master-slave synchronization:
1. When the master machine is running, the light will send DMX-512
signals, however, it can’t be connected to the controller, otherwise,
they will interrupt each other, so that can not be synchronized.
2. While many lights are using master-slave synchronization, only one of
them can be master, or they can’t be synchronized.
The connection of Master-slave synchronization as below:

7
Safety Marks:
1. Please make sure to switch off the power before installation or
maintenance.
2. Please keep the fan expedite and environment ventilated.
3. This laser projector is designed for the indoor, so while using,
please avoid any dripping. If you want to use outdoor, please do
enough waterproof measure.
4. Please get acquainted with the properties the light before
installation operating or maintaining, as most damage are caused
by wrong operating without acquaintance.
5. Do not use any power voltage or light type of different
specifications.
6. Please do not look at the laser light directly, in case it might
damage the eyes.
7. Avoid electric shock！
8. Do not use it frequently under the humid atmosphere.
Maintenance:
We suggest that clean the light with professional glass cleaning and downy
cloth. Keeping the light clean regularly can not only get the largest power of
the light.
all Copyrights by:
Musikhaus Thomann
Treppendorf 30
GER- 96138 Burgebrach
Tel.: [phone]
[email protected]
www.thomann.de