Steamtec TOLO-F100 User manual

___________________________________________________________________________
TOLO SAUNA [e-mail] www.tolosauna.com
1
AIO Exhaust Fan Manual
Please read the manual carefully before installation
and keep it for further reference
1. Configuration List
When receive the exhaust fan, please check if you get complete set according to below chart,
contact us immediately if any missing.
Table 1
2. Installations
Cautions
All circuits should be installed by licensed electricians and conform to local and national
codes.
Power supply must be cut off before installation, maintenance and repair. Press the on/ off
button on the controller can NOT cut power from the supply.
Make sure that the installation complies with each country’s current mechanical and
electrical norms.
This apparatus must not be used in explosive or corrosive atmospheres.
This appliance is not intended for use by young children or infirm persons unless they have
been adequately supervised by a responsible person to ensure that they can use the
appliance safely. Young children should be supervised to ensure that they do not play with
the appliance.
Make sure there are no loose elements near the ventilator, as they could run the risk of
being sucked up by it. If it is going to be installed in a duct,check that it is clean of any
element that could be sucked up by the ventilator.
When installing an apparatus, make sure that all the fittings are in place an d that the
structure which supports it is resistant enough to bear its weight at full functioning power.
Item code
Item name
1
Exhaust fan, 1pc
2
Cable (from fan to steam generator central box), 1pc

___________________________________________________________________________
TOLO SAUNA [e-mail] www.tolosauna.com
2
Installations of fan
Figure 1

___________________________________________________________________________
TOLO SAUNA [e-mail] www.tolosauna.com
3
Figure 2

___________________________________________________________________________
TOLO SAUNA [e-mail] www.tolosauna.com
4
Connecting Wires
1) Use the cable wire to connect exhaust fan (see connector in below figure 3) and AIO
steam generator central function box.
Figure 3
2) Connect wire terminal
Following below two steps:
(A) unscrew and open the wiring box (ref
to figure 4 );
(B) connect null wire and live wire (ref to
figure 5).
EU type 220 V single phase: Connect “N”and “LA”;
USA type 220V 1 phases: Connect two live wires to “N”and “LA”;
Please don’t connect anything to “LB”
Do NOT support EU type 380V 3 phases or USA type 220V 3 phases.
Figure 4 Figure 5

___________________________________________________________________________
TOLO SAUNA [e-mail] www.tolosauna.com
5
3. Functions And Operations
The working time setting is from 1-60 minutes, after time arrived, will stop working
automatically. Default time is 5 minutes.
The time show on the display is the remain working time.
Setting on controller
Touch
SET
until appear, then touch or to adjust time, then wait for 5
seconds until back to the home page.
Then after the steam bath, after the steam generator stop heating, touch the
FAN
to start
the fan. The time besides the icon of the fan is the remain working time of
the fan.
Figure 6

___________________________________________________________________________
TOLO SAUNA [e-mail] www.tolosauna.com
6
Setting on APP
Below functions can be also controlled on APP.
*Functions On/Off control
*Setting working time range
For more details, you may refer to APP manual.
Figure 7
4. Power and application
Model
TOLO-F100
Power
High 26W/Low 23W
Noise
High 31/Low 26dB
Air volume（per
hour）
High 198m³/Low165m³
Speed
High 2200/Low
1850r/min
Air pressure
High 156/Low 131pa
Size:
L302xW204xH195mm
Diameter
97mm
*The factory default is high speed. It is available to adjust the speed if you install a
speed-control switch.
Application: steam room/kitchen/washroom/bathroom/the room need fresh air
*If you use it in bedroom, TOLO have another super silent model.Please contact us at
[e-mail] for its more information.