Steelcraft Y-040 Series User manual

4 in 1 Portable cot
Series No. Y-040

WARNINGS
02
• FOLLOW THE MANUFACTURERS INSTRUCTIONS.
• MAKE SURE CHILDREN ARE KEPT AWAY WHILE YOU ARE
ASSEMBLING/DISASSEMBLING THE COT.
• ALWAYS APPLY THE BRAKES WHEN USING THE COT.
• DO NOT LEAVE YOUR CHILD UNATTENDED.
• USE ONLY THE MATTRESS SUPPLIED BY THE MANUFACTURER,
INCORRECT MATTRESSES CAN CAUSE DEATH.
• DO NOT ADD ANY EXTRA MATTRESSES AS IT MAY CAUSE
SUFFOCATION & DEATH.
• TO PREVENT FALLS THE BASSINET MUST NOT BE USED ONCE A
CHILD CAN SIT UP.
• NEVER PLACE A CHILD IN THE COT WHEN THE BASSINET IS IN
PLACE.
• NEVER PLACE A CHILD IN THE COT WHEN THE CHANGE TABLE IS IN
PLACE.
• ALWAYS USE THE HARNESS WHEN USING THE CHANGE TABLE.
• REMOVE THE TOY MOBILE FROM THE COT WHEN THE CHILD BEGINS
TO PUSH UP ON HANDS & KNEES.
• Check that the assembly of the cot is correct and safe.
•Check that all folding parts and locking devices are fully engaged.
before placing child in the cot.
WARNINGS: TO AVOID INJURY OR DEATH:
RETAIN FOR FUTURE REFERENCE.
READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE
OF THIS COT. ALWAYS FOLLOW THE INSTRUCTIONS.
THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT IS
ESSENTIAL.

•Do not place more than one child in the cot at the same time.
• Do not use your cot if any part is torn, broken or missing.
• Do not place toys or other objects in the cot which could provide a
step or foothold to help the child climb out.
• Cots with padded rails should not be used if the covering fabric has
been bitten through.
• Do not use or leave the cot near open res, naked ames, electric
bar res, gas res, stoves, heaters or barbecues.
• Do not place the cot where your child could reach medication,
money, string, elastic, small toys or other small objects.
• Do not place the cot near trailing or hanging cords, leads or exes
such as curtain cords, electrical cords or leads, etc.
• The thickness of the mattress has been specied to ensure that the
distance from the top of the mattress to the top of the lowest side
or end will always be at least 500mm. This will reduce the risk of the
child falling out of the cot.
• Using the wrong size mattress may create hazardous gaps that
could result in suocation or could reduce the side height of the
cot, which may result in your child falling out of the cot.
• Do not use parts or accessories other than those tested and
approved by Britax.
• Do not use this cot with a child who can climb out, weighs more
than 15kg, or is taller than 90cms.
• Always check parts regularly for tightness of screws, nuts and other
fasteners - tighten if required.
WARNINGS (Continued)

WARNING - MATTRESS SIZE
TESTED AND APPROVED ACCESSORIES
Mattress by Steelcraft - Series Y-040
Bassinet by Steelcraft - Series Y-040
Change Table by Steelcraft - Series Y-040
Toy Mobile by Steelcraft - Series Y-040
04
Using the wrong size mattress may create hazardous gaps that could
result in suocation or could reduce the side height of the cot which
may result in your child falling out from the cot.
To ensure the cots correct assembly and use, ensure you follow these
instructions in the order they are written.

05
A 1 x Carry Bag B1 x Mattress
D1 x Cot
F 6 x Bassinet Support
Rods
E1 x Bassinet
C6 x Mattress Support
Rods
PARTS LIST

06
PARTS LIST
G 4 x Corner Moulding H1 x Change Table
I1 x Toy Mobile Stand
& 3 Soft Toy

1. TO OPEN THE COT
07
A Unzip the carry bag and remove the cot.
BStand the cot on its feet and undo the hook & loop straps that
hold the mattress around the frame.
CRemove the mattress and set it aside.
DSeparate the legs of the cot.
A B
C D
IMPORTANT: THESE STEPS WILL ENSURE THAT
THE COT IS CORRECTLY OPENED AND READY TO USE.

NOTE: All the top rails should be locked in place. If they are not,
release them and try again. The centre of the cot base must be in
a raised position to allow the rails to lock easily. Check for the
secure engagement of the rails by pushing down on them.
GHolding one end of the cot clear of the ground, gently press down
in the middle of the base until the base until the base lays down
at. The base should now be locked into position.
1. TO OPEN THE COT (Cont)

1. TO OPEN THE COT (Cont)
09
I Secure the mattress to the cot by passing the loop straps through
the slot in the cot base and pressing it onto the hook attachment
strips, sewn to the underside of the cot base.
NOTE: Always secure the mattress before using the cot.
G H
I
WARNING: USE ONLY THE MATTRESS SUPPLIED
BY THE MANUFACTURER, INCORRECT MATTRESSES CAN
CAUSE DEATH.
H Place the mattress into the cot with its padded side facing up.

10
2. TO USE THE WHEELS (Where tted)
A Push the brake lever down to lock, or lift the brake lever up to
unlock.
NOTE: Always apply the brakes wherever and whenever you are
using the cot.
3. TO FOLD THE COT
THESE STEPS MUST BE FOLLOWED IN THIS ORDER TO EASILY FOLD
THE COT.
IF BASSINET, CHANGE TABLE OR TOY MOBILE ARE FITTED, THEY
MUST BE REMOVED BEFORE FOLDING THE COT. DO NOT STORE
THE TOY MOBILE WITH THE COT AS IT MAY CAUSE DAMAGE TO
THE MESH.
A Release the loop straps under the base that secure the mattress and
remove the mattress from the cot.
B Twist and pull the strap up in the centre of the base all the way.

3. TO FOLD THE COT (Cont)
C Release each top rail by lifting the rail slightly and squeezing on
the buttons, located on the centre joint. The buttons are
covered by the top rail fabric and are located at the centre of
rail.
IF THE TOP RAILS DO NOT FOLD - DO NOT FORCE THEM - LIFT THE
BASE HIGHER AND RE SQUEEZE THE BUTTONS TO FULLY
RELEASE THEM.
D Ensure that each rail is fully released and then pull up on the cot
base strap, while gathering the legs and the frame together until
it’s fully folded.
BC
D

12
3. TO FOLD THE COT (Cont)
E Take the mattress and wrap it around the folded cot with the
padded side facing inwards.
FThread the straps through the plastic loops, pull them tight and
secure using the hook and loop attachments.
GTake the carry bag and cover the folded cot. Finish covering the
cot and close the zipper.
E
G G
F

13
4. TO USE THE BASSINET
A Insert the 3, two piece support rods into bassinet inner sleeves
separately and engage the locking pin.
B Insert the mattress and secure it to the bassinet by passing the
loop straps through the slot in the bassinet base, then press the
loop straps onto the hook attachment, sewn to the underside of
the bassinet.
AB
WARNINGS: TO PREVENT FALLS, THIS BASSINET
SHOULD NOT BE USED ONCE A CHILD CAN SIT UP.
NEVER PLACE A CHILD IN THE COT WHEN THE BASSINET IS
IN PLACE.

14
C Connect the 2, two piece frame rods by engaging the locking pin.
Then insert the 2, two piece rods into the long sleeves of the
longest sides of the bassinet and the 2, one piece rods into sleeves
of the short sides. Insert rods into holes in the corner mouldings
and then attach the fabric covers in the corners of the bassinet to
the snaps on the plastic corner mouldings.
4. TO USE THE BASSINET (Cont)

15
4. TO USE THE BASSINET (Cont)
NOTE: Always secure the mattress before using the bassinet.
IMPORTANT: ALWAYS REMOVE THE BASSINET
BEFORE FOLDING THE PORTABLE COT.
DLower the bassinet into position, then push the mouldings onto
the corners of the cot & snap the clamps onto the side rails to
secure in place.

16
5. TO USE THE CHANGE TABLE
WARNINGS:NEVER LEAVE YOUR CHILD
UNATTENDED.
TO PREVENT FALLS THE CHANGE TABLE SHOULD NOT BE
USED ONCE A CHILD CAN SIT UP.
NEVER PLACE A CHILD IN THE COT WHEN THE CHANGE
TABLE IS IN PLACE.
ALWAYS USE THE HARNESS WHEN USING THE CHANGE
TABLE.
A
A Lay the change table face down with the four plastic hooks facing
up.
B Connect the tubes together on either side of the change table.
Insert one tube end into the other until the pin engages. Pull on
the tubes to make sure they are locked together.
B

17
5. TO USE THE CHANGE TABLE (Cont)
C Pick the change table up by the plastic hooks and connect to the
outside of the portable cot short end rail as shown.
DRotate the change table over the portable cot and engage each of
the four clamps onto the side rails.
NOTE: Make sure the four clamps are engaged on to the side
rails.

18
6. TO USE THE CHANGE TABLE (Cont)
E Pull the pocket flap over the end of the portable cot. Attach the
plastic clamps to the leg tubes to keep the pocket in place.
FWhen the change table is not in use, always fold over the end rail
until required again.
GTo remove the change table, release the plastic hooks from the top
rails.

19
6. TO ASSEMBLE AND USE THE TOY MOBILE
WARNING: ALWAYS ATTACH THE MOBILE
SECURELY TO THE COT ACCORDING TO THESE
INSTRUCTIONS. CHECK ATTACHMENT FREQUENTLY.
A Insert the mobile upper curved arm into the mobile lower arm
until locked together.
BConnect each of the three toys to the mobile tri-shaped hanger by
threading the string into the slot at the end of each hanger arm.
AB
BB

20
6. TO ASSEMBLE AND USE THE TOY MOBILE (Cont)
CInsert the connector on the round music box into the hole on the
mobile hanger and push until they lock together.
DSnap the moulding on the top of the music box into the end of
the upper curved arm.