STEMA UT01N-2T/A User manual

ASSEMBLY INSTRUCTION
Page 1 from 4

Make sure no obstacles are in the desk’s ath.
Make sure the deskto is not touching any walls.
Make sure all cords are a ro riate length to accommodate the
change in height.
WARNING
Pinch Point! Kee hands and fingers clear.
•Kee all electrical com onents away from liquids.
•Do not sit or stand on the desk frame. Do not crawl or lie under the desk frame.
•Do not o en any of the com onents - legs, control box, or switch.
•This roduct is designed with a duty cycle of 10%. (2 min. on, 18 min. off).
USE/LIABILITY
•This height adjustable desk has electric motors and is designed for use in dry work areas only.
•The desk height is adjustable so that it can be ositioned at the most ergonomically suitable height.
•Any other use is at user’s risk.
•Under no circumstances does the manufacturer acce t warranty claims or liability claims for damage caused from
im ro er use or handling of the desk frame.
PARTS
Required tools
Com onents
Page 2 from 4

ASSEMBLY INSTRUCTION
REMEMBER: always use screws that are about 2-3 mm shorter than the tabletop thickness. In the tabletop use
holes for screws with a diameter slightly smaller than the diameter of the screws.
Page 3 from 4

Plug the power cord into a 110 240 V outlet.
Make sure no obstacles are in the desk’s path.
Make sure the desktop is not touching any walls.
Make sure all cords are appropriate length to
accommodate the change in height.
Important: the desk must be reset prior to use.
Reset procedure: press and HOLD the DOWN BUTTON on the switch until the desk reaches its lowest height.
Relase the DOWN button. Press and hold the DOWN button again until the LED display „rES”. Relase the
DOWN button. Press nad hold the DOWN button again until the desk lowers a little bit more, slihtly rises and
stop. Relase the DOWN button. Your desk is now ready to use.
If Your desk is not functioning properly it may need to be reset. Unplug the power cord for 20 seconds. Plug
the power cord back in and follow the RESET procedure.
Page 4 from 4