stilum Jump S User manual

© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. [phone] • All rights and product modications reserved Stand: 22.01.2019 S. 1
Mounting instructions bouncing element „jump S“
Item no. 51462x125
Diagram 1: Overall view of the play equipment

© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. [phone] • All rights and product modications reserved Stand: 22.01.2019 S. 2
Mounting instructions bouncing element „jump S“
Item no. 51462x125
Diagram 2: Combined frost protection and load bearing layer
Diagram 3: Cut through installed Bouncing Element Jump S
1. Select the play equipment location in consideration of the required
safety area (s. diagram 4: 4250 x 4000 mm).
2. Carry out excavation work for the foundation as shown in diagram 3.
pit size: (LxWxH) 1600 x 1850 x 600 mm
excavation of the pit: 1,776 m³
Needed combined frost protection and load bearing layer material:
0,533 m³
Note: Lifting equipment is needed
3. Create combined frost protection and load bearing layer as shown in
diagram 2.
4. Screw the eyebolts into the existing holes and use as lifting point.
5. Lift Bouncing Element Jump S and place it in the middle of the pit.
6. Unscrew eyebolts.
7. Fill the gap with parts of excavation.
8. Think about safety surface.
9. For a maximum fall height of 1000 mm safety surface must be accor-
ding to EN 1176-1, chart 4.
For a bouncing element, the extent of the clearance must be 1500 mm
horizontally around the jump surface, measured at each point of the
edge, and 3500 mm above the jump surface.
10. Do not allow children to use the equipment before the installation has
been nished.
Attention: If the play equipment has been incompletely installed or partly
dismantled when carrying out maintenance and repair work, this may lead
to particular risks of injury for the user. For this reason, make clearly visible
that the equipment shall not be used in such cases.
5
Drawing 2: Combined frost protection and load bearing layer
Drawing 3: Cut through installed Bouncing Element Jump S
5
Drawing 2: Combined frost protection and load bearing layer
Drawing 3: Cut through installed Bouncing Element Jump S

© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. [phone] • All rights and product modications reserved Stand: 22.01.2019 S. 3
Mounting instructions bouncing element „jump S“
Item no. 51462x125
Diagram 4: Top view
Extent of the minimum zone =
safety area
4
4. Dimensions
Drawing 1: Dimensions safety area
For a bouncing element, the extent of the clearance must be
1500 mm horizontally around the jump surface, measured at
each point of the edge, and 3500 mm above the jump surface.