Stone STAD101WT-15 Technical Document
Android industrial control LCD display
Model
STAD101WT-15
Equipment Manual
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 2
Contents
1 Android LCD Specification Introduction............................................................................ 3
1.1 Introduction.....................................................................................................................3
1.2 Technical Parameters...................................................................................................4
2 Interface Description............................................................................................................ 6
2.1 Serial Ports.....................................................................................................................6
2.2 USB-HOST Interface.................................................................................................... 7
2.3 USB-DEVICE Interface.................................................................................................7
2.4 GPIO Interface...............................................................................................................7
2.5 Network Interface.......................................................................................................... 7
2.6 HDMI Interface...............................................................................................................8
2.7 Button.............................................................................................................................. 8
2.8 TF Card Holder.............................................................................................................. 8
2.9 Audio Interface...............................................................................................................8
2.10 WIFI and Bluetooth Module.......................................................................................9
2.11 4G Module....................................................................................................................9
2.12 GPS Module.................................................................................................................9
2.13 LED Interface.............................................................................................................10
2.14 SIM Card Slot Interface............................................................................................10
2.15 4G Antenna Interface............................................................................................... 10
2.16 Mounting Method...................................................................................................... 10
3 Accessories......................................................................................................................... 11
3.1 Antenna Selection.......................................................................................................11
3.2 Speaker.........................................................................................................................11
4 Physical Dimensions..........................................................................................................12
5 International Certification...................................................................................................13
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 3
6 Naming Rule........................................................................................................................14
1Android LCD Specification Introduction
1.1 Introduction
STAD101WT-15 Android LCD is a new model Android LCD by STONE Tech.
It is equipped with 1.8GHz Quad-core Cortex A17, a high performance low
energy cost industrial controller.
Dimensions: 256*170*33 mm
Weight：1.2 kg
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 4
1.2 Technical Parameters
Main Parameters
Parameter
Description
CPU
RK3288/Quad-core 1.8Ghz
ARM Cortex™-A17
System
Android 5.1.1
Rooted
RAM
2GB
4pcs 512MB,2G DDR3
eMMC
8GB
EMMC
GPU
ARM
Mali-T764
OpenGLES1.1/2.0/3.0
OPEN VG1.1, OPENCL,
Directx11
Display Parameters
Parameter
Description
Interface
MIPI
Resolution
800x1280
16:9 Ratio
Touch Type
Capacitive
3 point multi-touch armored glass
Luminance
450 cd/m2
Viewing Angles
Full viewing angles
IPS
Peripheral Interfaces
Interface
Quantities
Description
Power
1
DC 5.5*2.1MM
Serial port
4 RS-232, 2 RS-485
2 RS-485 multiplex with RS-232,
232 port is PH-2.0MM-10P
connecto, 485 port is
PH-2.0MM-4P connector
USB
4 HOST, 1 DEVICE
External 4 USB HOST
Audio
1 MIC, 2 SPK
Two channel 4R/3W speaker,
SPK connector is PH2.0MM-4P,
the speaker is Built-in (Optional)
Ethernet
1
10/100Mbps self-adaptive
network interface
HDMI
1
HDMI2.0 common interface
TF Slot
1
TF Card slot
SIM Slot
1
Standard SIM card
GPIO
4
IO interface, support 3V3 IO,
connector isPH2.0MM-5P
4G
1 (Optional)
7 Mode full Netcom
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 5
WIFI
1
AP6212 Bluetooth & WIFI 2-in-1
Support Bluetooth 4.2
Bluetooth
1
GPS
1 (Optional)
GPS Global positioning, support
GPS and BeiDou Dual-satellite
navigation (optional), this module
is integrated with 4G module
Antenna
WiFi
Standard configuration 25 cm
rod antenna (dBi 3.0), 3m sucker
antenna optional (dBi 5.0)
GPS (Optional)
Active antenna (dBi 5.0)
4G (Optional)
Standard configuration 25 cm
rod antenna (dBi 3.0), 3m sucker
antenna optional (dBi 5.0)
Buttons
1
1 Button for programming
LED
2
1 power LED，1 heart-beat LED
Mounting Hole
4 mounting screws (Optional)
Can be fixed according to
requirements
Power Supply
Parameter
Min
Typical
Max
Unit
Operating Voltage
9
12
30
V
Operating Current
620
mA
Reliability Test
Min
Typical
Max
Unit
Operating Temperature
-10
25
70
℃
Storage Temperature
-20
75
50
℃
Operating Humidity
5
95
RH%
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 6
2Interface Description
2.1 Serial Ports
STAD101WT-15 is integrated with 4 serial ports. UART1, UART2, UART3,
UART0 are RS-232 level converted, All have been treated with anti-static
treatment.
UART3,UART4 is RS232 and RS485 hardware reuse（UART3,UART4 is
either for RS232, either for RS485, they can’t be used at the same time）.
RS485 bus can support 32 transceivers theoretically, it’s recommended to
use less than 24 transceivers. This is influenced by working environment
and wires.
Serial port definition as table below,
Notice：UART2 serial port is the debug port. There will be printing information appear
while start-on. It can be used as the normal serial port after start-on.
232 Interface(J15):
Screen printed
Interface
Pin
Device Node
Level
1R
UART1
1
TtyS1
RS232
1T
2
2R
UART2
3
TtyS2
RS232
2T
4
GND
5
3R
UART3
6
TtyS3
RS232
3T
7
4R
UART4
8
TtyS4
RS232
4T
9
GND
10
485 Interface (J16):
Screen printed
Interface
Pin
Device Node
Level
3A
UART3
1
TtyS3
RS485
3B
2
4A
UART4
3
TtyS4
RS485
4B
4
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 7
2.2 USB-HOST Interface
The STAD101WT-15 has integrated 4 USB-HOST. These 4 USB
interfaces can be connected to a variety of USB peripherals, such as USB
keyboard and mouse, U disk, USB interface camera (support UVC
protocol) and other commonly used peripherals.
Current：USB output 5V, single USB port max current 500mA, total max
current 2A
USB / C is a native USB interface. It is recommended to connect a USB
camera to this interface.
2.3 USB-DEVICE Interface
DEV interface is USB-DEVICE interface. This interface can only be used
for system programming and ADB debugging.
2.4 GPIO Interface
GPIO interface, only support 3V3 signal pin. Voltage 3.3V, GPIO default
pull-up, as output 3.3V 4mA, as input the voltage must below 3.3V,
otherwise circuit may be damaged.
PIN
Definition
1
GND
2
GPIO3_D3-U
3
GPIO3_D1_U
4
GPIO4_B1_U
5
GPIO3_D0_U
2.5 Network Interface
The STAD101WT-15 is a 100M adaptive Ethernet interface that is
brought out via RJ45. If you want to use Android's Ethernet function, you
need to plug the network cable into the ETH interface and then turn on the
Ethernet function by setting. The default Ethernet is DHCP-assigned IP. If
you want to manually configure the IP address, you can configure it in the
advanced settings.
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 8
2.6 HDMI Interface
HDMI is a high-definition screen interface with 4 sets of differential lines.
The HDMI mark is printed on the enclosure. Users can connect multiple
display sizes. The default resolution is 1920 * 1080.
2.7 Button
STAD101WT-15 has 1 button, the function as follow：
1. FLASH button；(Normally used for programming)
Please refer to the user manual on how to use flash button to upload
the .img image file.
2.8 TF Card Holder
The onboard leads 4-bit data cable to the TF card holder, supports
large-capacity storage. It is designed for hot-swap detection, supports
eMMC protocol 4.3 and SD Memory Card protocol v2.0.
2.9 Audio Interface
The MIC is the microphone jack, and the SPK is the left channel speaker
jack. The SPK interface is an 4R/3W amplifier circuit.
Interface
PIN
Definition
MIC
1
MICIN1N（RIN1）
2
MICIN1P（LIN1）
SPK
1
+OUT_L
2
-OUT_L
3
-OUT_R
4
+OUT_R
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 9
2.10 WIFI and Bluetooth Module
STAD101WT-15 is equipped with Bluetooth WIFI 2-in-1 AP6212 module.
AP6212 can support Bluetooth 4.2 protocol 2.4G WIFI, after pairing, it
supports the function of transferring files with mobile phones and other
devices.
2.11 4G Module(Optional)
The mother board supports the 4G module of the MINI-PCIE interface. If
you need to use the 4G function, you only need to insert the module into
the mother board, then put the SIM card into the card slot to use the 4G
function.
The mother board card slot supports only the Micro SIM card.
The 4G module supports
TD-LTE/FDD-LTE/TD-SCDMA/WCDMA/EVDO/CDMA1X/GSM mode,
please refer to chart below and confirm with your network operator first.
Note: The SIM card is slanted to the outside.
Supported Band
Frequency
TD-LTE
B34/B38/B39/B40/B41
FDD-LTE
B1/B3/B5/B8
TD-SCDMA
B34/B39
WCDMA
B1/B8
CDMA1X
BC0
GSM
900/1800MHz
2.12 GPS Module(Optional)
The STAD101WT-15 is equipped with a GPS-enabled 4G module to
support fast and accurate positioning. If you need this function, you need
to put the GPS antenna in the open space. When you turn on the
Android positioning function, you can get the latitude and longitude
coordinates of the device at this time. The STAD101WT-15 supports
BeiDou Dual-satellite navigation at the same time. Please contact
engineer for details.
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 10
2.13 LED Interface
The STAD101WT-15has two LED lights. The POWER light is the power
indicator. When the Android screen is normally powered, the POWER
light stays on. USR blinks when the system is running normally, and
always on when abnormal.
2.14 SIM Card Slot Interface
Put the SIM card into the slot. Note that the SIM card does not support
hot plug, the device must power off and restart when you plug the SIM
card. SIM card slot at the top of PCB board. It supports 7 modes as
table below:
2.15 4G Antenna Interface
User can choose matching antenna with different interface to enhance
signal and extend distance.
2.16 Mounting Method
There are 4 mounting holes on the shell
Standard: Mounting hole on the backside 75*75，Screw-thread M4
Optional: Clips with screw M4*25
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 12
4Physical Dimensions
Speaker 8R5W 100*45
Stereo Speaker PH2.0-4P
Cable length 80 cm
External,Optional
Speaker 8R5W 100*45
Stereo Speaker PH2.0-2P
Cable length 80 cm
External,Optional
Speaker 4R3W
TS7033BOX-01-L350
PH1.25-2P/ Speaker 2040
4R2W Rectangle Full-band
Mono Speaker
Cable length 20 cm
External/Internal,Optional
All rights reserved by STONE
Technologies
STAD101WT-15 Equipment Manual www.stoneitech.com
Release 01/2019 15
ST
Company Code
AD
Android
070
TFT Panel Dimension: 7 inch
W
W=Wide Voltage
C
C=With Capacitive Touch Screen
T=Tempered GlassTouch Screen
R=Infrared Touch Screen
0
0= Standard Configuration 1= High Configuration
1
1=Without Case 5=Metal Case
Intelligent Customer Online Services
Intelligent Customer Support offers comprehensive additional information of
Intelligent Products through its Online services as follows:
- Official website: https://www.stoneitech.com/
http://www.stone-hmi.com/
- Alibaba platform: http://shuangying-ocean.en.alibaba.com/
http://stonetech.en.alibaba.com/
- Telephone: 0086-10-84351669
- E-mail: info@stone-hmi.com
Other support
In need of technical queries, please contact STONE representatives in the subsidiaries
and branches responsible for your area.
Table of contents
Other Stone Monitor manuals
