Storyteller Overland MYVOLTA User manual

MYVOLTA
BLUETOOTH
HARDWARE
INSTALLATION
INSTRUCTIONS
REV 02.01.2021

LET’S GO!!
Thank you for your purchase. This is an easy install but please read
these Installation Instructions before getting rolling with this project.
Take your time and be mindful with the tools as personal harm and/or
damage is possible if you're not careful.
Only install this product with the supplied hardware as substituting or
modifying hardware could damage your awesome rig.
Thank you for supporting the overlanding community. We are jealous
that we can't join you out on the open road and beyond, but sincerely
hope this product will enrich your travels.
—Your pals at Storyteller Overland
2

1. (1) myVolta Bluetooth module
2. (1) myVolta Y cable
PARTS INCLUDED:
TOOLS NEEDED:
1. T 20 Torx screwdriver
2. Your hands
3

STEP 1:
Remove the product from the
package and insert the single end
into the myVolta Unit.
STEP 2:
With your Volta system powered
OFF remove the (4) 1/2" Torx T 20
Hex screws that hold the M-Power
Control Center panel in place
indicated by the
STEP 3:
Let the M-Power Control Center
panel hang gently. Disconnect the
wire going into the center of the
State of Charge gauge.
4

STEP 4:
Remove the adhesive and stick the
myVolta box on the inside of the
panel (steps 1-4).
STEP 5:
Connect the female end of the Y
cable to the back of the SOC
gauge.
Connect the male end of the Y
cable to the existing wiring
harness.
REMOVE
1 2
34
5

STEP 6:
Replace the (4) T 20 Torx screws
in the M-Power Control Center
face plate (do NOT over tighten)
and you’re all finished.
STEP 7:
Download the myVolta app and
connect. Refer to:
voltapowersystems.com for more
information.
6

WARRANTY
VOLTA MANUFACTURES AND OFFERS A WARRANTY
ON THIS SYSTEM. IF, BY CHANCE THIS PRODUCT FAILS,
PLEASE CONTACT VOLTA DIRECTLY.
VOLTAPOWERSYSTEMS.COM/CONTACT
.

MYVOLTA APP REV 2.1,2021
1