Subaru Impreza User manual

—1
—
G E NUINE PA R T S
INS TAL L ATION INS T R UC T ION
T IT ANIUM S HIF T K NO B for MA NUA L
TR A NS MIS S ION (M/T)
PA R T NUMB E R : C 1010FA100
AP P L IC AT IO N :IMP R E ZA
Y 0135
(1) P ull s hifter boot down away from exis ting s hift
knob.
(2) Un-screw and remove existing shift knob.
Y 0136
If the s hift knob is exces s ively heated/ cooled by air temperature and/ or s unlight,
toughing it may res ult in a s uperficial burn or fros tbite.
When s hifting under s uc h conditions , we recommend wearing driving gloves or
waiting until the s hift knob reac hes a s uitable temperature.
C AUT ION
05MY +
-04MY

—2
—
(3) R emobe any debris with a clean brush.
Y 0137
(4) S crew the TITANIUM S hift knob onto the
stalk until tight.
NOT E : That “S TI” should not be crooked, but
horizontal to the instrument panel.
Y 0138
(5) R e-install shifter boot onto the new shift knob.
Y 0139
Y 0140-1
(6) C lean area where the S hift P attern Decal is to be installed with Isopropyl Alcohol,
allow to dry before applying decal.
(7) R emove backing paper and apply S hift P attern Decal on cons ole as s hown.
Y 0140-2
1.0mm
NOTE 3
NOTE 4
05MY +
-04MY
NOT E 1: B ottom edge of S hift P attern Decal should alogn with (but not overlap) rear edge of console panel.
NOT E 2: S hift P attern Decal is applied at center of cons ole panel rear extension area.
NOT E 3: B ottom of S hift P attern Decal s hould be parallel to the forward edge of the control s witches or
switch cover with approximately 1 mm gap separation.
NOT E 4: S hift P attern Decal is aligned with the left (driver's side) edge of the control s witches.