Installation Information
2-2
CONVECTION MICROWAVE OVEN
INSTALLATION INFORMATION
The Wolf convection microwave oven can be set up as
a free-standing unit or set into a built-in wall installation.
This section of the manual covers some of the installa-
tion issues that a service technician may need to know
when servicing a Wolf convection microwave oven. If
additional installation information is needed after
reviewing this section of the manual, please refer to the
installation guide or contact the Wolf Appliance
Customer Service Department.
Electrical Requirements
• 110 to 120 Volts AC, 60Hz, 15 ampere fused electri-
cal supply
• Separate electrical circuit serving only this appliance
• A properly grounded 3-prong receptacle
Line
Voltage
(Power)
Neutral
Ground
TOAVOID SHOCK HAZARD, NEVER REMOVE THE
GROUND PRONG FROM THE PLUG OF THE POWER
SUPPLYCORD.
Free-Standing Installation
With the convection microwave free-standing on the
countertop, it is recommended to have counter space
on at least one side of the appliance. At least 2 inches
of clearance must be allowed on the sides, top and at
the rear of the appliance for air circulation. (See Figure
2-2)
THE INSTALLATION SITE MUST BE EQUIPPED
WITH APROPERLYGROUNDED 3-SLOT RECEPTA-
CLE TO MATCH THE 3-PRONG (GROUNDED)
POWER SUPPLYCORD PROVIDED ON THE APPLI-
ANCE. IF THE ELECTRIC RECEPTACLE OR POWER
CORD ARE NOT PROPERLYGROUNDED, THIS
COULD CAUSE ASHOCK HAZARD AND THE APPLI-
ANCE MAYNOT FUNCTION.
Ground Prong
Figure 2-1. Electrical Receptacle & Power Cord
Figure 2-2. 2” Clearance on Sides, Top & at Rear
•EXTENSION CORDS ARE NOT RECOMMENDED.
•IF AN EXTENSION CORD IS NECESSARY, USE
ONLYA3-WIRE CORD WITH A3-PRONG PLUG
AND A3-SLOT RECEPTACLE, RATED FOR 115 -
120VOLTS, 15 AMPOR HIGHER.
•DO NOT DRAPE EXTENSION CORD OVER COUN-
TERTOPOR TABLE WHERE IT CAN BE PULLED
ON OR TRIPPED OVER ACCIDENTALLY.
