Operation Manual
Camera
UTC
MENU
LCD
SOURCE
SELECT
PD36319
WARNING:
HD CAMERA INPUT CVBS LOOP OUT
CAMERA
SPEC
DC12V OUT
CAMERA IN:
TVI / AHD / CVI
5M / 4M / 3M / 1080P
/ 720P / CVBS
CVBS
LOOP OUT 12VDC 1A OUTPUT AND LED
CAMERA TYPE
Battery: Standard 5200mA / 3Hr
Optional (Add-in Second Battery): 10400mA / 6Hr
Introduction
7 inch Portable LCD Test Monitor
for HD-TVI, HDCVI, AHD, CVBS with
HDMI, DVI, VGA Video Inputs (Up
to 5MP Cameras)
The 7 inch LCD test monitor supports HD-TVI, HDCVI,
AHD, and CVBS cameras up to 5MP. Includes HDMI, DVI,
and VGA video inputs and a CVBS BNC loop out. A
camera type indicator provides information on your
camera (type and resolution) with a guideline indicator
to allow adjustment of the camera angle. UTC control is
also provided for compatible cameras. Powered by a
removable li-ion battery for up to 3 hours of
usage or add in a second battery to increase usage up
to 6 hours
Operation
1. Turn power switch on
2. Wait 10 seconds for the unit to operate
3. Connect HD-TVI / HDCVI / AHD / CVBS camera to HD
Camera input (BNC input) and then push the Source
Select button until you hover over the CVBS input
source. Wait 2 seconds for display to show camera
or
Connect HDMI, DVI, or VGA input source (e.g. DVR) and
then with the same procedure above, select the input
source
4. Press the menu button located beneath the Source
Select button to adjust the LCD’s contract, brightness,
color, or sharpness
5. Use the Camera UTC buttons to control cameras with
UTC functionality (Note: the buttons are not opera-
tional if UTC is not available on the camera)
6. Push the Camera Spec button to show camera type
and resolution
7. CVBS Loop Out allows output onto an additional
CVBS (BNC) display
8. 12V DC 2A input provides charging for the monitor
9. 12V DC 1A output provides power for the camera
10. Battery charging LED indicator will be red when
charging and blinking green when low on battery (30%
or below)
11. Provided Li-ion battery provides up to 3 hours of
on-screen use. Add in a second optional battery to
increase capacity up to 6 hours
12.
Built-in kick stand allows the monitor to be propped up
13. Hand carry bag included for on-the-go use and
protection
Features
• 7 inch TFT LCD monitor
• Supports HD-TVI, HDCVI, AHD, and CVBS cameras
• Supports resolutions up to 5MP
• NTSC / PAL
• OSD menu
• UTC control
• Camera type indicator. Shows the type of camera used
and resolution
• Color bars provide display indication
• Guideline indicator to adjust camera angle
• HDMI, DVI, VGA video inputs
• CVBS BNC Loop out
• 12V DC 2A input provides charging for the monitor
• 12V DC 1A output provides power for the camera
• Removable 18650 Li-ion battery provides up to 3
hours of on-screen use. Add in a second optional
battery to increase usage up to 6 hours
Please make sure you are plugging in the
DC inputs / outputs correctly. Plugging in
incorrectly may damage your camera
Note: The test monitor outputs to NTSC / PAL and
will display the resolution to 720 x 480. The unit is
designed for adjusting focus and angles; refer to the
DVR for real-time picture quality.