Super Tramp Polymesh Wallaby Bed Administrator Guide

Tel: [phone] | www.supertramp.co.uk | [email protected]
Adult installation required
Read User Guide before installation
Please keep this guide for further reference
A ‘HOW TO’GUIDE
Replacing
A Polymesh Wallaby Bed

1First,you will need to remove your old bed from the trampoline.
Begin by removing a spring from the frame using a spring tool,then cross over to the other side of the trampoline
and remove the opposite spring. Continue this process of creating a mirror image on each opposite side because
this process helps to evenly distribute the tension through the bed,making the spring removal process much
easier.
Use the diagram below for reference.
Remove the corner springs last.
STEP
Replacing your Rectangular Wallaby Trampoline Bed
Tel: [phone] | www.supertramp.co.uk | [email protected]
1 2 3 7 8 9
4 5 6 10 11 12
13
14
15
16
17
18
Replacing
A Polymesh Wallaby Bed

Tel: [phone] | www.supertramp.co.uk | [email protected]
2Remove the packaging
from your new bed and
unfold it on the ground
inside the trampoline
frame. Make sure the
painted markings are
facing upwards.
STEP
Using a
Spring
Tool
Bed
Standard
Hook
If you require replacement anchor straps or
springs for your Boomer, these can be ordered
though our website:
www.supertramp.co.uk
Wallaby Springs:
8.57 INCH (218MM)
SKU: ZZWALL5PK
TO ORDER SPARES
Anchor Straps
SKU: PGTPAS00STDBK
Kangaroo
Elevator Kit
SKU: WALLELEKIT

Tel: [phone] | www.supertramp.co.uk | [email protected]
3Using the diagram below as an example, begin to fit the new bed to your trampoline following the
sequence 1-10.
You should continue to work at opposites at all times to evenly distribute the tension through the bed,
(Example shows following the numbers within squares to eventually fitting the remaining springs until all
74 springs are attached.
STEP
Reattach the elevator kit
and then the frame pads
Frame pads
7
STEP