Surfsight RemoteFound AI-12 User manual

surfsight.net| [e-mail]
WARNING:This type of installation should be performed by aqualified individual or professional only.Working with
your vehicle's power system can be dangerous to both you and your vehicle if you do not know what you are doing! If
you have any doubts, please consult aprofessional.
For up to date support articles and installation guides please visit our support web pages at surfsight.net
1. Insert SIM and SD Card
In case the camera is not pre-installed with an SD and SIM cards, please follow the
following step to insert the SD and SIM cards. Using the specialty screwdriver supplied
with the product, unscrew the safety screw that locks the tamper proof case of the SD
card and SIM card on the side of the camera.
2. Mount the camera
Attach the mounting bracket to the camera, remove the 3M adhesive tape cover and
mount the camera to the windscreen. The camera should be placed as high as possible
on the driver side of the vehicle.
Make sure the glass is clean and dry before attaching the 3M adhesive mount to the
windshield.
WARNING
Do not install the product in a location where it can obstruct the drivers field of vision.
* Refer to the user guide for detailed instructions on first time calibration and setting
the camera positions.
Package Contents
Installation Steps
AI-12 Camera Mounting
Bracket
Hardwire Kit Specialty
Screwdriver
The hardwire kit includes an add-a-fuse that that includes a fuse tap.
The fuse tap included is meant to be put in the “Fuse 1” position, while the fuse that you
select from the fusebox goes into the “Fuse 2” position. (only if you are using a slot with
an existing fuse). If you set them up with the wrong order, it will not feed power to the
hardwire kit.
*Select a fuse that has Ignition Power, connect it to a fuse port that has power only
when the car is turned on (verify this during installation)
3. Insert Fuse Tap into Add-A-Fuse Kit
Add-A-Fuse
Kit
Fuse Tap
HARDWIRE KIT
QUICK SETUP GUIDE

Using needle nose pliers (or a similar crimping tool), trim off some of the
rubber tubing (if necessary) to expose some wiring on your hardwiring
cable. Connect that cable into the other end of the add-a-fuse (metal
tube), then crimp them down together to make the connection. Once the
crimping is done, use some force to tug on the add-a-fuse and wire so that
nothing is loose. If everything feels tight, then the crimp is good and the
connection is properly made.
4. Crimp the Add-a-Fuse Kit to Connect the Hardwiring Kit Cables Together
Once everything is complete, the add-a-fuse simply needs to be put back
into the slot that the fuse was taken out of.
Open the vehicle fuse box and connect as follows:
1.Red Color Wire –Ignition Power, connect it to a fuse port that has power
only when the car is turned on (verify this during installation)
2.GND –Find a reliable iron port to connect affix the ground wire to the
iron port.Please note the ground wire of your hardwiring kit does not
need an add-a-fuse kit and only attaches to a metal ground bolt.
5. Put the Add-a-Fuse Back into the Fuse Slot
6. Connect the camera
The power cable connects to the round connector located on the side of the camera.
After Power is connected, run the power cable along the headliner of the car along the A-
Pillar to the power source.
Run the power cable along the headliner of the car along the A-Pillar to the power source.
surfsight.net| [e-mail]
HARDWIRE KIT
QUICK SETUP GUIDE