SWEEX TV023 - QUICK_START_GUIDE User manual

1
Contents
1 PREFACE
3
2
SAFETY
PRECAUTIONS
3
3 IN THE CARTON
5
4
FRONT&BACK
4 CONNECTIONS OF
LCD
6
5
INSTALLTION
DRAWINGS
Power Cord Connection 7
Antennas Connection 7
SCART Connection 8
YPbPr Connection 8
S-Video Connection 9
VGA Connection 9
HDMI Connection 10
DVD&CI CARD Connection 10
6 REMOTE CONTROL
Remote control instructions in TV mode 11
Remote control instructions in TELETEXT mode 12
Remote control instructions in DTV mode 13
Remote control instructions in DVD mode 14
Remote control setup 15
7 ACCESSORIES
15

2
8 TV OPERATION
First Time Installation 16
TV Information 17
VIDEO menu options 18
Audio menu options 19
Setup menu options 19
Timer menu options 23
Function menu options 23
9 DTV OPERATION
Program List 26
Channel List options 26
Favorite List options 26
Channel Search options 27
EPG MENU 28
10 DVD OPERATION
Basic operation 29
MP3/JPEG Playback 29
DVD Function General setup 30
System Setup 30
Language Setup 33
Audio Setup 34
Video Setup 34
Dolby Digital Setup 35
11
TROUBLESHOOTING
AND ADVICE
36

3
PREFACE
Thank you for buying this TV! Please read this manual thoroughly before operating the TV. Make sure the TV was not
damaged in transit. Should the TV is damaged, do no install it and contact your dealer. Check that you have all the
accessories according to the model.
SAFETY PRECAUTIONS
Preparation
Put the TV on a stable surface.
Do not place any material on the TV.
Minimum distances Do not use the TV with fixtures other than those provided or suggested by the
manufacturer.
Do not block or cover the ventilation openings on the TV. If you have a wall mount,
check that it is steady.
Connexion cables
Power cord and cables must be properly routed and protected to prevent people
from stepping on them and causing the TV to fall.

4
Heating sources and humidity
Keep the TV dry and away from humidity.
Keep the TV away from heat sources.
Cleaning and maintenance
Unplug the TV before cleaning it. Do not use solvent or liquid to clean the TV.
Only clean the TV with a soft and dry cloth.
In case of troubleshooting, do not use spare parts other than those suggested by
the manufacturer. Using inadequate spare parts can lead to electric shocks, short-
circuits fire or other incidents.
Departure in holidays
Unplug the TV during lightening storms or when unused for long periods of time.

5
IN THE CARTON
-/--
LCD TV SET Remote Control
GB Manual
IT Manuale d’istruzioni
NL Gebruikershandleiding
FR Manuel d’utilisation
EC Declaration of Conformity
9
User Manual AAA Batteries

6
FRONT&BACK CONNECTIONS OF LCD
Front View
1. Press “V+” or “V-” to increase or decrease the sound level;
2. Press “P+” or “P-” to scan through channels;
3. Press “MENU” to bring up the main menu to the screen;
4. Press “SOURCE” to select the input source;
5. Press “POWER” button to turn standby mode on or off;
6. STOP in DVD mode;
7. PLAY/PAUSE in DVD mode;
8. OPEN/CLOSE in DVD mode;
9. POWER INDICATOR: show red in standby mode, show
green when your TV is switched on;
10. REMOTE SENSOR: infrared sensor for the remote
control.
Back View and Control Connections
1. HDMI: Connect the HDMI output jack of DVD;
2. VGA: Connect the PC-RGB output jack of PC;
3. SCART: Connect the SCART jack of VCR;
4. S-VIDEO: Connect the S-VIDEO output jack of DVD or
VCR;
5. YPbPr: Connect the YPbPr output jack of DVD or VCR;
6. PC AUDIO: Connect the Audio output jack of PC;
7. YPbPr/S-VIDEO AUDIO: Connect the Audio output jack of
DVD or VCR for YPbPr/S-VIDEO;
8. RF: Connect the antenna;
9. CI Port: Connect the CI CARD.

7
INSTALLTION DRAWINGS
Power Cord Connection
1. Connect the power cord correctly as shown.
2. Press the POWER switch of your LCD V to switch on the LCD TV. The power indicator on the front panel lights up
in Green
Antennas Connection
To ensure good picture and sound, TV antenna system needs to be installed. The antenna system as Shown above
can be sourced from TV equipment shops, which will provide service for correct installation and connection. After
installation, insert the 75-ohmantenna plug into the antenna jack as shown above.
RF
PC
AUDIO
YPbPr/S-Video
Audio
75 OHM
ANTENNA
PLUG
VHF ANTENNA VHF ANTENNA
OUTDOOR
ANTENNA
AMPLIFIER
INDOOR
ANTENNA
AMPLIFIER
POWER PLUG
OF ANTENNA
AMPLIFIER

8
SCART Connection
Connect the SCART connector on the external video device to the SCART connector on the set using a SCART cable.
TV Back
Scart cable
DVD or VCR Back
DVD or VCR
YPbPr Connection
Connect the YPbPr output of the DVD or VCR to the YPbPr input on the set. The picture quality is improved compared
to connecting a regular VCR to the video input. Connect the Audio output of the DVD or VCR to the Audio input jacks
on the set using the RCA cable.
Match the jack colors :Y is green, Pb is blue, and Pr is red, Audio left is white and Audio right is red. Select YPbPr
input source with using the SOURCE button on the remote control.
DVD or VCR
RCA Audio Cable
RCA Video Cable
TV Back
DVD Back

9
S-Video Connection
Connect the S-VIDEO output of the DVD or VCR to the S-VIDEO input on the set. The picture quality is improved
compared to connecting a regular VCR to the video input.
Connect the Audio output of the DVD or VCR to the Audio input jacks on the set using the RCA cable. Select S-VIDEO
input source with using the SOURCE button on the remote control.
DVD or VCR
Audio Cable
S-Video Cable
TV Back
DVD or VCR Back
VGA Connection
Connect the RGB output of the PC to the VGA jack on the set. Connect the AUDIO output of the PC to the PC AUDIO
jack on the set .Select the VGA input source with using the SOURCE button on the remote control.
Stereo Audio Cable
VGA Cable
TV Back

10
HDMI Connection
Connect HDMI output of the DVD to the HDMI input jack on the set. Select the HDMI Input source with SOURCE
button on the remote control.
HDMI Cable
TV Back
DVD or VCR
DVD or VCR Back
DVD&CI CARD Connection
WARNING:
MIRROR SIDE TOWARDS USER
DISK SLOT
CI CARD