Swift Info Technology SGVT-01 User manual

1
SGVT-01 GPS Vehicle tracker’s User Manual
（GPS+GPRS+GSM）
Product Manuals
Version 1.0

2
Attention before use this terminal:
Please mount the device steadily on the flat place before using;
Please make sure the voltage value is right before connecting with battery,
and placing the wires to where shouldn’t be trodden;
Please power off when plugging or taking out of any module or connector;
Please keep the device dry and don’t let any liquid fall into the device in
case any damage caused in the device or circuit;
If any problem caused as follows, please turn to professional technician:
When power wire, keyboard, or socket are damaged;
When liquid infiltrating into the device;
When the device work unusually or cannot resume to normal even
operated according to the instruction;
When the device cannot as usual after falling, throwing or breaking;
When there is obvious damage in the device.

3
Catalog
1、Products Introduction ···························································································4
2、Main Features ······································································································4
3、Detailed Specifications······················································································· 5
3.1、Hardware parameters····················································································· 5
3.2、Other················································································································· 6
4、Interface definition································································································6
4.1、Power Interface························································································7
4.2、Extension Interface··················································································7
5、Intelligent Terminal Installation ·············································································8
5.1、Terminal Installation Tips·······································································8
5.2、Installation steps and parameter settings··············································9
6、Standard Accessories·························································································10
6.1、Terminal Standard accessories ···························································10
7、Common Faults·································································································· 11
8、Optional accessories··························································································13
8.1、9PIN extension line··············································································13
8.2、Monitor Line·························································································13
8.3、Off oil relay··························································································13

4
1、Products Introduction
SGVT-01 G PRS/GSM model GPS smart terminal (mobile user terminals) which
built-in Industrial GPRS / GSM communication module and the latest SiRF-Star
III high sensitivity GPS receiver positioning module, Using dual-mode GPRS
and SMS communication. Terminal operate stable, reliable, full of features and
many interfaces. Can be used for mixed, leasing, logistics, public transport,
bus, dangerous goods vehicles, rental cars in different areas. Also according
to different industries, different user makes suitable products for customer.
2、Main Features
1 Terminal dimensions small, waterproof, easy installation;
2 GPS positioning accuracy, dynamic positioning deviation is less than 5
meters;
3、support for GSM SMS and voice function under, GPRS state of UDP /
TCP protocol communications;
4、support for GPS data uploaded regularly and named functions
5、support for silent features；
6、Remote monitoring capabilities to support authorized
7、Support the acquisition and high voltage, low voltage protection；
8、Support 3-way high-, low level signal detection
9、Support blind transfer function up；
10、Car remote lock function
11、Support the emergency alarm；
12、Support power-off alarm function (built-in backup battery)；
13、Support for high-pressure alarm and under voltage alarm
14、Speed alarm function support
15、Support the parking alarm；
16、support the illegal open, illegal start alarm；
17、Support the fatigue driving function；
18、Statistical functions to support mileage；

5
19、SMS alarm notification
20、Built-in 16MB Flash, can save 30 thousand blind track data
3、
、、
、Detailed Specifications
3.1、
、、
、Hardware parameters
Operating Voltage
8VDC～36VDC
Operating Current
50mA~160mA
GSM Module Containing frequency GSM 900/1800
Containing GSM 850/900/1800/1900Mhz
(Customizable)
Communication
protocol UDP/TCP(Customizable)
GPS Module Latest GPS SiRF-Star III Chipset
GPS Sensitivity -159dBm
GPS Frequency L1, 1575.42 MHz
C/A Coding 1.023 MHz chip rate
Passage 20 Channel View Tracking
Location accuracy
10 Meters, 2D RMS
Speed Accuracy 0.1 M / s
Time accuracy GPS time synchronization
Default data WGS-84
Regain Average 0.1 seconds
Hot Start Average 1 sec
Warm Start Average 38 seconds
Cold start Average 42 seconds
Height restriction 18,000 meters (60,000 feet) max

6
Speed limit 515 km / sec (1000 knots) max.
Acceleration limit Less than 4g
3.2、
、、
、Other
Operating
Temperature -20°～70°C
Storage
temperature -30°～85°C
Humidity
5% ～95% No coagulation
Terminal size 101 mm × 50mm × 24mm
Built-in battery Not less than 2 hours continuous work
LED Red: the host state; Yellow: communication module
status;
4、
、、
、Interface definition

7
4.1、
、、
、Power Interface Picture：
：：
：
Pin Description
pin
colors Function / Connection Method
1 red Power input is, the working voltage of 9VDC ~ 34VDC,
then the positive car battery;
2 black Power input negative, then the negative car battery;
3 yellow ACC test line, take the car keys ACC line;
4.2、
、、
、Extension Interface Picture：
：：
：
Pin Description
pin
colors Function / Connection Method
1 orange LV1(Check one low), input low voltage detection, detection voltage range is less than 0.3VDC, which can be accessed
need to detect the low effective signal line;

8
2 red SOS Alarm input, low level alarm is triggered, SOS alarm
button direct access line;
3 brown SOS alarm indicator signal, drive led lights, when alarm is
triggered, led lamp lights；
4 white
HV1 (detection of a high, defined as the illegal open / illegal
start moving signal detection line), input is voltage
detection, detection voltage range of 5VDC ~ input supply
voltage, which can be accessed need to detect the high
effective signal line;
5 Space Not defined
6 Purple SOS Alarm land
7 Yellow Shutoff relay control positive, then the yellow line relay；
8 black Shutoff relay control negative, then relay white line;
9 blue HV2 (high test 2), input is voltage detection, detection voltage range of 5VDC ~ input supply voltage, which can
be accessed need to detect the high effective signal line;
5. Intelligent Terminal Installation
5.1, Terminal Installation Tips Tips
1、Before installation, open to the Mobile SIM card mobile GPRS data
services。(SIM card GPRS data services to be opened CMNET access
through GPRS (such as GSM and related business cards), rather than
through CMWAP access GPRS (such as M-Zone card). Doubts, please
consult your local mobile company; also have to apply for traffic SIM card
package, you can apply for 10M or 20M or 50M. SIM card billing unit shall be
the smallest byte (BYTE). equipment used in the normal flow of work: 1
minute monitoring time is 5 ~ 8M, 30 seconds to control once 10 ~ 12M, traffic
accounting bytes.
2. The SIM card number and license plate numbers of vehicles to be installed
and other relevant records of vehicle information is good, sent to the
monitoring center to register, such as the control center is not registered,
the system can monitor vehicle. .
3、GPS car terminal in Consuming (later referred to as car terminal), check
the GPS-vehicle terminal, SIM card, GPS antenna, GPRS antenna, car
handles, power cable, I / O expansion line, emergency alarm buttons,
spare batteries, relays, microphone and other configurations are consistent

9
with customer demand;
4、On-site installation of GPS vehicle terminal before the test in the indoor
environment, the GPS car terminal and the set of accessories (to be installed
accessories to customers) connected with a regulated power supply or
backup battery power to the GPS car terminal, GPS car terminal and to
ensure All accessories can work.
5、Field Installation Notes:
5.1、First test car voltage is normal and whether the voltage range of GPS
car terminal supply voltage range, the choice of access to power, the
power to try to select the vehicle's main power supply (direct and
battery power cord connections);
5.2、Choose to install GPS vehicle terminal position, as far as possible
away from the car automotive electronics equipment and other heat
source devices, especially wireless devices and high power electronic
equipment, and to install strong, so as to avoid shock damage to the
big time GPS car terminal;
5.3、The products are all-weather antenna can be installed in the car
outside the suitable position. Directly by an external antenna installed
at the bottom of the magnetic absorption in the metal roof. Concealed
installation for installation in the former instrument panel plastic cover
on the back, the trunk lid on the back or other plastic objects hidden
under the Note GPS antenna to have a certain range of the visible sky
is not being metal shell, coated glass such as shelter materials.
Antenna wire is not loose some attention fixed and reliable and should
not be through the door and so can squeeze in animals to prevent
breakage.
5.4、Do not live swap SIM cards, so as not to burn card.
Attention: Power in the access before the first GPRS antenna and GPS
antenna connected, the ACC line connected, the power cord is
recommended to pick car or car battery master switch back online.
5.2、
、、
、Installation steps and parameter settings
Open the front panel screws, gently remove the circuit board, the SIM card
into the SIM circuit board on the back deck, take time to pay attention to
possible PCB hands do not touch the circuit board components in order to
avoid static damage to circuit boards;
GPS and GPRS antennas to tighten immediately good；
To insert into the public back-up battery 2PIN positive 2PIN mother board

10
seat, normal, circuit board began charging, the indicator lights;
Select a good car power access points, the external input power supply
terminal access；
Flashing red and yellow light are normal, you can set the start text
messaging terminal, the specific set up instructions are as follows:
S, * APN *, * IPAddress *, * port number * phone number * *, * No * SMS *
SMS Verify Password *
APN: import address carrier network, such as CMNET so.
IP: a single byte less than 3, the high position 0 if 58.60.185.172 Make
* 058.060.185.172 *;
PORT: server port；
Local Number: terminal ID, to 13 at the beginning of the length of the
number of 11 vehicles;
SMS service numbers: numbers in the terminal services active alarm
messages will be applied to, to add country code before the number,
such as domestic 13512345678, [phone] * should *, service
is the vehicle computer equipment SMS text message service number
corresponding to the target number to open
SMS verification code: factory default is 123456, must be 6 digits;
Such as :
：
：：
： S,*CMNET*,*058.060.185.172*,*8886*,*13512345002*,*[phone]*,*123456*
Setting is successful, the terminal should return OK! Message content;
Such as ：OK!94090001, ID: 13820090001
Normal terminal landing platform, the circuit board into housing, a good panel
with screws, in place fixed the terminal and antenna, and organize the line,
recovery vehicle lines and demolished part of the panel, the installation
basically completed.
Notes：
Parameter input must be correct, or not normal landing platform, the
proposed set up after the T command with SMS query parameters are correct,，
And in monitoring the platform check is normal on-line terminal.
6、
、、
、Standard Accessories
6.1、
、、
、Terminal Standard accessories
Standard accessories：
：：
：Power cord, GPS antenna, GPRS antenna, velcro,
warranty card, warranty card receipt, certificate

11
Accessories Pictures
七
七七
七、
、、
、 Common Faults
GPS intelligent terminal fault keys
Serial
NO Failure phenomenon
Fault diagnosis / troubleshooting
1
Unable to
access the
network or
GPS car
terminal
name is not
on the scene
and observed
light is off
Detection of power supply is correct access
equipment;
Detection of power line fuse is broken；
Detection of the power cord and car power
connection is loose or office;
If the test is normal, may be equipment is
damaged, please contact with equipment
suppliers to solve;
2
Can visit the
GPRS
network or
GPS car
terminal upon
to normal, but
showed no
GPS
positioning
Check whether the car was in the GPS signal
blind area, blind, or you can leave and then
observed over time, determine: whether the field
detection of green LED lights flash once
approximately 1 second, if normal, continue with
the following test;
Access car handle (if not previously installed),
make the terminal self-test, if the GPS terminal
normal self, continue with the following test;
GPS antenna and vehicle detection terminal
interface is loose;
Detection of the first GPS antenna placement or
antenna is moving overhead to the metal
block;
Replacement GPS antenna, GPS antenna detect

12
damaged
If the above test are normal, fault has not ruled
out, please contact with equipment
suppliers to solve;
3
Unable to
access GPRS
network or
GPS car
terminal can
not connect
Check whether the car was in the GSM signal
blind area, blind, or over time from another
observation, to judge;
Detection of yellow LED lights if the scene is
about 1 second flash once, if not normal, to
below detection;
Detect SIM card is loose;
detect whether the SIM card arrears；
detect SIM card is burned；
detect GPRS antenna is loose or damaged;
If the above test are normal, fault has not ruled
out, please contact with equipment suppliers to
solve;
4
Can not send
and receive
text
messages or
send GSM
SMS GPRS
Check whether the car was in the GSM signal
blind area, blind, or over time from another
observation, to judge;
Detect the SMS platform obstruction (such as
peak holiday to send and receive text
messages) or Mobile GPRS network failure, if it
is the problem, returned to normal mobile
network, equipment failure automatically return
to normal;
Detection GPRS antenna is loose or damaged;
5 Can not make
calls
If the GPRS network is normal, and service /
dispatch center to confirm whether the phone
call limit set;
Testing to confirm whether the opening voice SIM
card
Detect whether the SIM card arrears；
Detection of the handle and GPS vehicle terminal
connection is normal;
If the above test are normal, fault has not ruled

13
out, please contact with equipment suppliers to
solve
6 Can not set,
set the failure
Replacement handle reset;
Replacement of the host to reset；
Replacement confirmed by the results, determine
the reasons for failure.
8、
、、
、 Optional accessories
8.1、
、、
、9PIN extension line
8.2、
、、
、Monitor Line
8.3、
、、
、Off oil relay