Swing-N-Slide NE 3051 User manual

1LDR 02-22-2018 LA 9430
Specifi cations subject to change without notice.
Manufactured for: Swing-N-Slide® • 1212 Barberry Drive • Janesville, Wisconsin 53545 • USA • 1-800-888-1232 • www.swing-n-slide.com
Made in USA • Printed in USA
NE 4720, NE 4720-1T, NE 4720-1Y, NE 4720-3Y, NE 4720L, SP 2600, SP 2610, SP 2620, SP 2660,
SP 2670, SP 2680, SP 3029, SP 3079, SP 3088, SP 3099, SP 3100, SP 3200, SP 3300, SP 3500, WS 8200, WS 8201, WS 8202, WS 8336, WS 8337
Slide Mounting Instructions
WARNING: ASSEMBLY BY ADULT.
Not Included In Kit: Tools Required:
Assembly:
Fig. 2
Fig. 1
Fig. 3
Screw Deck
Slide Block
Deck Screw
NE 3051, NE 3052, NE 3053, NE 3054, NE 3060, NE 3061, NE 3062, NE 4675-12PK, NE 4675-12T,
NE 4675-1PK, NE 4675-1T, NE 4675-3PK, NE 4675-3T, NE 4675L, NE 4675LY, WS 8334, WS 8335
Weight Limit: 250 lbs For children 2-10 years of age
Stake
2” x 4” x 17”
Use Pressure-Treated Wood
1-3/4”
17”
Cut
1-3/4”
(2) 1-1/4” screws
Pre-drill holes with 1/8” drill bit fi rst
Pre-drill dimple holes through slide with 1/4” drill bit fi rst
72”
USE ZONE
21”
21”
2” above ground 1-3/4”
Minimum
1-3/4” Minimum
Tape Measure Hammer
1/8” & 1/4” Drill Bits
Phillips Bit
1-1/4” Truss Screws (not included)
(3 or 4 depending on model)
Stake
2” x 4 ” x 17 ”
Use Pressure-Treated Wood
Electric Drill
Circular Saw
x4
1-1/4”
(3,2 cm)
1/4”
(6 mm)
1/2”
(12,7 mm)
Truss Screw
Screw must be to sizes shown at a
minimum. Do not use a screw size shorter
than 1-1/4” (3,2 cm) long.
x2
1-1/4”
(3,2 cm)
Deck Screw
Screw size should be a #8 thread size
minimum and coated for use with
treated wood.
Fig. 4
Important: Slide could have three or four individual dimples or four sets of dimples. If it has a set of four dimples, use one screw at each set of dimples. Avoid locating dimples over any
gaps in the playset deck. Check for screws protruding underneath the deck. If screws protrude, add a wooden slide block underneath the deck to cover screw ends. See Fig. 4 for an
example slide block.
ASSEMBLY STEPS
1. Consult (Fig. 1) for proper placement of slide on your unit. Make certain no objects lie within the grayed out area, or ‘Use Zone.’ Position slide to determine proper location for stake.
IMPORTANT: Place the slide on level ground, not less than six feet from any structure or obstruction such as a fence, garage, house, overhanging branch, laundry line or electric wire.
Protective surfacing must extend a minimum of 6ft. in all directions from the perimeter of the equipment or from the outermost edges of any component. A slide extending beyond the
platform must have protective surfacing at least 6ft. out from both sides as well as the end. An area of 21” on either side of the slide should be free of obstructions which a child’s arm could contact.
2. Drive wood stake (not included) into ground leaving 2” exposed (Fig. 2).
3. Using an 1/8” drill bit, drill (2) holes through the side of the slide and into stake. Secure the slide bottom to the stake using (2) 1-1/4” deck screws (Fig. 2).
4. Attach slide to unit as shown in (Fig. 3).
x1
For 48” (121,9 cm) Deck Height
Instructions below apply to the following models:
For 60” (152,4 cm) Deck Height

2
Safety Checklist for Play Sets and Accessories
Observing the following statements and warnings reduces the likelihood of serious or fatal injury
Installation Safety – Have You:
Consulted the assembly instructions supplied with your particular model?
Noted this accessory is to be used only on approved designs? (Do not alter its design or add/remove components.)
Made sure all hardware is tightened securely? (Supplied bolt covers must also be fastened securely.)
Using a hacksaw, cut off all protruding threaded ends of bolts and other fasteners and remove any sharp edges with a metal fi le as needed, and coated fastener ends with lead free paint?
Placed the equipment on level ground, not less than six feet (1.8 meters) from any structure or obstruction such as a fence, garage, house, overhanging branches, laundry lines, or electrical wires?
Made sure home playground equipment is not installed over concrete, asphalt, packed earth or any other hard surface? (A fall onto a hard surface can result in serious injury to the equipment user.)
Verifi ed that suspended climbing ropes, chain, or cable are securely anchored at both ends and cannot be looped back upon itself?
Consulted in assembly instructions of your particular model for minimum use zones?
Used a water sealant on your play set to protect the wood and prevent cracking and warping?
Followed all anchoring and shock absorbing surfacing requirements below as they apply?
Made sure not to allow children to use equipment until it is properly installed?
Made sure to adjust all swings so there is a minimum 8’’ clearance between the swing and the ground surface?
Operating Safety – Have You:
Determined that on-site adult supervision is provided for children of all ages?
Warned children of the following before allowing them to use the equipment?
Not to walk close to, in front of, behind or between moving items.
Not to twist swing or any other accessory chains or ropes or loop them over the top support bar since this will reduce the strength of chain or rope.
Not to swing empty seats or other accessories.
Not to slide down swing chains.
Be sure to sit in the center of the swing seat and other accessories with full weight on the seat.
Not to attach items to the playground equipment that are not specifi cally designed for use with the equipment such as but not limited to, jump ropes, clotheslines, pet leashes, cables and chain.
They may cause a strangulation hazard.
Not to climb or walk on the top of swing beams, railings or roof.
Not to use equipment in a manner other than intended.
Not to get off equipment while it is in motion.
Not to climb on the equipment when it is wet.
Be sure to go down slides feet fi rst.
Determined that only one child per planned occupant seat should be allowed on this set at one time.
Determined children must be dressed appropriately for play. Avoid hooded jackets, bicycle or other sports helmets, clothing with draw strings and loose fi tting clothes which could become
entangled or snagged on equipment.
Determined that suspended climbing ropes, chain, or cable are securely anchored at both ends and cannot be looped back upon itself.
Made certain the slide is placed so that is is not in direct sunlight.
Safety Maintenance – Follow these preventive maintenance instructions at the intervals required:
To prevent the deterioration of materials, remove plastic swing seats and other plastic accessories when outdoor temperature dips down to or below 32° F and take indoors. Reinstall these plastic
elements at the beginning of each play season.
At the beginning of each play season check metal parts for rust. If found, sand and repaint using a non lead-based paint meeting the requirements of 16 CFR 1303 or SOR/2005-109.
At the beginning of each play season and once a month during each play season, check all moving parts for wear, rust or other deterioration. Replace as needed. If any of these conditions exist, call
1-800-888-1232 to order replacement accessories.
At the beginning of each play season and once a month during each play season lubricate metallic moving parts.
At the beginning of each play season and twice a month during each play season, check all protective coverings on bolts, pipes, edges, and corners. Replace if they are loose, cracked, or missing.
At the beginning of each play season and twice a month during each play season, rake and check depth of loose fi ll protective surfacing material to prevent compaction and maintain appropriate
depth. Replace as necessary.
At the beginning of each play season and twice a month during each play season tighten all hardware.
At the beginning of each play season and twice a month during each play season, check all wood members for deterioration and splinters.
Sand down splinters and replace deteriorating wood members.
Disposal Instructions
When the equipment is taken out of service, it must be disassembled and disposed of in such a way that no unreasonable hazards will exist at the time the set is discarded.
Save this instruction sheet in the event the manufacturer needs to be contacted.
This product is intended for single family home/residential use only and not intended for use in any public setting. Placement in public settings constitutes misuse of this product.
IMPORTANT! ADDITIONAL REQUIRED SAFETY INSTALLATION INSTRUCTIONS
According to ASTM requirements, all kits must be anchored to the ground and, if the unit has a climbing rope, the rope end must be anchored. If soil conditions permit stakes to be pulled out easily, cementing into
ground is necessary.
To anchor the unit to the ground, Follow the instructions included in this plan for applying Anchor-It devices to your unit, or use 2” x 4” x 18” (45mm x 95mm x 457mm) pressure-
treated stakes. Pound stakes into ground at least 12” (305mm) at all inside corners of the posts (including A-frame legs and climbing unit posts). Attach with four (4) 3-1/2” screws
(approved for treated wood) per stake into each tower and/or A-frame upright.
If the unit has a climbing rope, securely anchor the rope at both ends.
Once the unit is completely assembled and before children are allowed to play on it, proper shock-absorbing surfacing material must be installed. This may be accomplished by
using loose-fi ll materials at a suffi cient depth. The Consumer Product Safety Commission “Handbook for Public Playground Safety” lists the following materials and required depths
that are suffi cient for home/residential application. Supplemental information may be found in ASTM F1292. For fall height protection up to 9 ft. (2.742m) (recommended for all kits):
LOOSE FILL MATERIAL REQUIRED (UNCOMPRESSED) DEPTH1in. (mm)
Wood Mulch 9” (229mm)
Double Shredded Bark Mulch 9” (229mm)
Uniform Wood Chips 12” (305mm)
When properly installed, shock absorbing material will completely cover the horizontal baseboards on climbing units. This protective surfacing must extend a minimum of 6 ft. (1.828m) in all directions from the
perimeter of the equipment or from the outermost edges of any component. For example, a slide extending beyond the platform must have protective surfacing at least 6 ft. (1.828mm) out from both sides as well
as the end. For swings, the protective surface must extend at least 14 ft. (6m) out from both the back and front of the swing when the swing is in its rest position.
1These depths were derived from the CPSC Handbook. has not done independent tests to determine these required depths.
Play sets and accessories
designed for children,
ages 2 to 10 years, unless
otherwise specifi ed

3
Swing-N-Slide® takes great pride in the quality and durability of our products. Our Manufacturer’s Limited Warranty provides confi dence and
demonstrates our commitment to providing quality residential playground products.
MANUFACTURER’S LIFETIME LIMITED WARRANTY
Swing-N-Slide® warrants its thermoformed slides and climbing mountains to be free from defects in workmanship and materials, under normal
use and conditions, for the lifetime of the product.
MANUFACTURER’S 5 YEAR LIMITED WARRANTY
Swing-N-Slide® warrants its Custom Ready-to-Build Play Set kits to be free from defects in workmanship and materials, under normal use and
conditions, for a period of 5 years.
MANUFACTURER’S 5 YEAR LIMITED WARRANTY
Swing-N-Slide® warrants its No-Cut and Wood Complete Ready-to-Assemble Play Set kits against wood rot and termite damage, and to be free
from defects in workmanship and materials, under normal use and conditions, for a period of 5 years for structural wood components.
Cosmetic defects that do not affect the structural integrity of the product, or natural defects of wood such as warping, splitting, checking, twisting,
shrinkage, swelling or any other physical properties of wood that do not present a safety hazard, are not covered by this warranty.
MANUFACTURER’S ACCESSORY, PLAYHOUSE WARRANTY
Swing-N-Slide® warrants its playset accessories and accessories sold separately as follows: Rope, Canopy/Tarps/Fabrics, Playhouses – 1 year.
Plastic Components, Chains, Hardware and Fasteners – 5 years. These items to be free from defects in workmanship and materials, under normal
use and conditions, for the period specifi ed.
Swing-N-Slide® will repair, or at its discretion, replace any part within the stated warranty period which is defective in workmanship or materials.
This decision is subject to verifi cation of the defect upon delivery of the defective part to Swing-N-Slide® at 1212 Barberry Drive, Janesville,
Wisconsin, 53545. Any part(s) returned to Swing-N-Slide® must have prior approved Return Authorization Number and proof of purchase,
including the date of purchase. This warranty is valid only if the product is used for the purpose for which it was designed and installed at a
residential, single family dwelling. This warranty is void if the product is put to commercial or institutional use. This warranty does not cover (a)
products which have been damaged by acts of Nature, negligence, misuse, or accident, or which have been modifi ed or repaired by unauthorized
persons; (b) the cost of labor; or the cost of shipping the product, any part, or any replacement product or part.
Swing-N-Slide® DISCLAIMS ALL OTHER REPRESENTATIONS AND WARRANTIES OF ANY KIND, EXPRESS, IMPLIED, STATUTORY OR
OTHERWISE, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE. Swing-N-
Slide® WILL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES. This warranty is non-transferable and does not extend
to the owners of the product subsequent to the original purchaser. Some states do not allow limitations on implied warranties or exclusion of
incidental or consequential damages, so these restrictions may not be applicable to you. This warranty gives you specifi c legal rights. You may
also have other rights, which vary from state to state.
This warranty also does not apply to:
• Structures not erected, maintained or inspected in conformance with Swing-N-Slide® installation plans
• Structures that have had parts added or substituted not in conformance with Swing-N-Slide® installation plans
• Parts that have been modifi ed, altered or misused
• Parts that have not been used as designed or intended
• Damage due to acts of Nature, vandalism, abnormal use or abuse as determined by Swing-N-Slide®
Swing-N-Slide® MANUFACTURERS LIMITED WARRANTY
LDR 02-22-2019LA 9430
Warranty and Registration
Register your product online at
www.OnlineWarranty.net