SWIT TD-R230S User manual

choosing SWIT products,Please read the instructions before using and keep it for future reference.
！WARING
Do not allow the adapter to come into contact with rain.请
Keep the electrodes clean and do not allow a short circuit
between them
Make sure that the power of the equipment using the
electricity meets the battery specifications.
Please mount the adapter reliably on a stand to prevent
serious damage due to drops.
characteristics
compatible with SWIT high voltage and dual voltage
batteries and can output up to 48V/750W with the SWIT
HB-C420S 3-core XLR connector.
One SPEAKON interface, supports 22~33.6V battery
direct out power.
Dual LEDs for individual channel status indication.
Compatible with tripods with diameters from 25mm to
45mm.
Small size and innovative fanless cooling design for
quieter and more convenient use.
Symmetrical design for a more stable centre of gravity.
Description of appearance
①Locking device
②LED indicator
③Vmount plate
④Mounting brackets
⑤48V 3-core XLR
⑥Adapter switches
⑦SPEAKON
Oversize
Model
TD-R230S
Output
interface
3-core XLR
SPEAKON
Input
voltage
range
Starting voltage：
25.6~35V
22~33.6V
Undervoltage value：
23V
Output
power
750W、48V─15.6A
750W、22~33.6V ─
17.4A
Operating
temperature
-20-40℃
Net weight
Around 1.3kg
SIZE
146*123*110 mm
Note：1. It is recommended to use the same type of battery with
the same power level；
2. 48V/750W output with SWIT HB-C420S only
3. With other batteries mounted, the maximum output
power is the maximum output power of the adapter or the sum
of the outputs of the two batteries (whichever is smaller)
4. The 3-core XLR output can only be turned on when
the battery is mounted at a voltage in the range of 25.6~35V;
the 3-core XLR output is turned off when the battery is
discharged at a voltage below 23V.
Instructions
1．When the adapter switch is switched off, the LED indicator
goes out and there is no output from the discharge port.
2．LED indicator：
Indicator status
Green
The battery is reliably mounted and the
current channel is normal.
Slow flashing
red light
The battery is about to run out of power,
please replace the battery as soon as
possible.
TD-R230S
Light pole dual battery snap-on adapter
USER MANUAL
SWIT Electronics Co.,Ltd. Tel：[phone]
Fax：[phone]
http://www.swit.cc
E-mail: [email protected]

Red
The battery is depleted.
Red light
flashing
In case of short circuit, over current, over
temperature protection and other abnormal
conditions, please unplug all the batteries
and cables, wait for the adapter to drop to
room temperature or re-plug the batteries
can be restored.