SwypeGear SwypeSound User manual

SwypeSound
User Guide

Congratulations on your purchase of the eco-friendly SwypeSound speaker!! Your speaker
plays MP3s stored on SD cards, MemoryStick, Multi Media Cards or USB media. You can also
use the audio input at the rear to connect your iPhone, iPod, smartphone, tablet or pretty much
any other audio device to jam out. The speaker comes with a built-in battery that lasts up to 5
hours. Perfect for wireless play at the beach, on the road, or wherever you may wander.
For more product information and warranty instructions, please visit www.swypegear.com
Technical parameters:
1. Output power: RMS 3W x 2 or 8W x 2
2. Signal to noise ratio: ≥85db
3. Frequency effects: 20Hz-20 KHz
4. Rated voltage: 3.7V/800mA
5. Loudspeaker unit: 52mm 4Ω3W x 2
Care: Avoid high temperature and wet environments.
Store in low temperature and a cool dry place. In case
of any liquid spills on the speaker, turn off the power
button immediately and only use after checking with a
professional repairer. Do not attempt to take apart this
speaker.

3
Front Panel Instructions Back Panel Instructions Remote Control Instructions
Back
Short press is for previous song or radio
station;Long press is to decrease the volume
Forward
Short press is for the next song or radio station;
Long press is to increase the volume
Play/Pause
Short press is for play/pause or automatic
searching of channels
LED Indicator
ON: Indicates that the device is switched on
Blinking: Card is being read
Blinking with FM on: Automatic search mode
Power Light
In charging state, the light is red
OFF/ON
Power off/on button
INPUT
Standard input line to connect with
computer, smart-phone or any other
audio source
DC IN 5V
Connect USB line jack for charging
OUTPUT
Connect a headset
Mode
Cycle through USB/SD/FM modes
EQ - Equalizer
Cycle through Classical/Rock/Normal/Pop/Jazz
 Back (see front panel instructions)
 Forward (see front panel instructions)
Play/Pause (see front panel instructions)
Cycle button
One press - Beginning of current song; press
twice to loop through all songs playing; press 3
times to random selection mode
Numeric keys
Select songs and radio stations

4
Playback: When no input devices are connected, the radio will play when the device is turned on. Please note that there
will be no sound output if there is a cable connected to the stereo input. The radio cuts off when media is inserted into the
USB/SD slots or through the stereo input. For iPhone/iPod users, you can charge your device through the front USB port
but playback is recommended using the 3 mm stereo cable.
Charging: Your SwypeSound speaker has an internal battery. It can be charged via USB. There is no AC input but the
USB cable can be connected to a USB wall adapter (not supplied in the box). Before charging, turn off the power button.
While charging, the Charge Indicator Light will be red. After full charge, disconnect as soon as possible to ensure longer
battery life. Charge time is about 3-4 hrs and the power lasts 3-5 hrs depending on the play modes and volume. Please
note that FM reception quality can degrade during charging. Also, we do not recommend keeping the battery plugged in as
it reduces the life of the battery.
Tuning: Use the center button in the front for scan feature. Once you find a station you like, turn off the power button to
stop the auto scan. Left and right buttons will work for fine tuning. There are no presets. Please note that the left
and right buttons in front also double as volume buttons if pressed long.