APEX-SYMAC Series Installation Instructions
2
DISCLAIMER
Symmetry Office intends to make this manual accurate and
complete. However, Symmetry Office makes no claim that the
information contained herein covers all details, conditions or
variations, nor does it provide for every possible contingency in
connection with the installation or use of this product. The
information contained in this document is subject to change
without notice or obligation of any kind. Symmetry Office makes
no representation of warranty, expressed or implied, regarding
the information contained herein. Symmetry Office assumes no
responsibility for accuracy, completeness or sufficiency of the
information contained in this document.
Symmetry® is a registered trademark of Symmetry Office. All
rights reserved.
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Do not use this product outdoors.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the APEX-SYMAC Series
Monitor Arm and the desk up to (and including) the display
does not the weight limits listed in the table below. Use with
products heavier than the maximum weight indicated may
result in collapse of the mount and its accessories causing
possible injury.
--SAVE THESE INSTRUCTIONS!--
MODEL Max Weight
Allowed for
EACH Display
Max Weight
Capacity of
Mounting
System
APEX-SYMAC1 22 lbs
(9.98 kg)
22 lbs
(9.98 kg)
APEX-SYMAC2 22 lbs
(9.98 kg)
44 lbs
(19.96 kg)
APEX-SYMAC2D 9 lbs
(4.08 kg)
18 lbs
(8.16 kg)
APEX-SYMAC3 7.5 lbs
(3.4 kg)
15 lbs
(6.8 kg)
