Pole Mounting Kits for the 4300 6U Outdoor Cabinet Installation Instructions
4300-A2-ZZ49-00 November 2005 3
Table 1 - Pole Mounting without Pedestal
Have the following equipment ready before beginning this procedure:
One drill
One 3/4” x 12” drill bit
One 9/16” wrench
Two 15/16” wrenches
A pencil
Model PDN-4300-F1-600 Pole Mounting Kit
Follow this procedure for pole mounting:
1. Pre-assemble the upper and lower horizontal brackets to the vertical bracket as shown in the above Figure.
2. Select a convenient mounting location on the pole.
3. Position the mounting bracket assembly against the pole and mark on the pole the location of the two (2) 5/8 “
bolts (item 27).
4. Place the mounting bracket assembly out of the way.
5. Drill two (2) 3/4” (19.05 mm) diameter holes completely through the pole at the locations marked in step 3.
6. Insert machine bolt (item 27) through mounting bracket and into the top mounting hole and press bolt and
bracket flush against the pole.
7. Place round-cupped washer (item 30), with the concave side in, on bolt and finger tighten nut.
8. Repeat step 6 for the remaining bolt.
9. Secure the mounting bracket assembly to the pole by securely tightening the machine bolts to 40 ft-lbs for
wooden posts and 100 ft-lbs for metal posts.
Item No. Qty Description
003 1 Bracket, Vertical Pole Mount, 10U/13U
006 1 Bracket, Lower Pole Mount, Access
009 1 Bracket, Upper Pole Mount
012 4 Nut, Nylon Top Lock 3/8"
015 14 Washer, 3/8" Stainless Steel, SAE, Flat
018 10 Screw, 3/8-16 x 1", Stainless Steel, Cap
021 6 Washer, Split Lock, 3/8 ZP
024 6 Washer, 3/8", Flat, Rubber
027 2 Bolt, Square Head, 5/8-11 x 16 & Nut, Galvanized
030 2 Washer, Curved, 2 1/4 x 2 1/4 x 3/16, 5/8, Galvanized
033 2 Nut, 5/8, Galvanized (Included with Bolt)
036 2 Washer, Square, 2 1/4 x 2 1/4 x 3/16, 5/8, Galvanized
