Tala Alumina User manual

Thank you for making the switch to Tala.
Discover the full Tala product family at tala.co.uk
IP20 220 - 240V
INSTALLATION GUIDE
Alumina Lamp
BEFORE STARTING
Please read instructions thoroughly before installation and keep them
for future reference. Please take extreme care when dealing with
electrical equipment.
IMPORTANT
Bulb must be installed in xture before turning on.
WARNING
Ensure power is turned OFF before inserting plug.
CARE AND CLEANING
We recommend cleaning with a soft dry cloth. Do not use abrasive
materials as these will damage the nish of the product.
WARRANTY AND AFTER-CARE
This product has a three-year warranty. If there appears to be a
functional defect with the product during this time, please contact our
team at [email protected]. The external exible cable or cord of
this luminaire cannot be replaced; if the cord is damaged, the luminaire
shall be destroyed.
EU/UK

Table Conguration STEP 1
Insert your bulb into the top of the lamp,
rotating clockwise until tight. Take care not
to tighten too much to avoid breakage.
STEP 2
Insert the lamp plug into your chosen
wall socket, making sure the power is
switched off.
STEP 3
Switch the power on and rotate the dial on
your dimmer until the bulb lights up. Adjust
the dimmer for your desired light output.

Wall Conguration STEP 1
Remove your bulb from the lamp, rotating
counter clockwise and set aside.
STEP 2
Remove the small lock screw from
the side of the lamp with the hex key
provided.
STEP 3
Slide the lamp towards the cable to
disconnect it from the base. Lift the
lamp and set it aside.

STEP 5 (OPTIONAL)
If you wish to hard wire the lamp into
the household mains, please consult a
qualied electrician before performing this
modication. Note, junction boxes are not
provided.
STEP 4
Attach the lamp base to the wall using the
orientation displayed below. Always choose
screws and plugs that are appropriate for
the wall, and ensure the wall cavity is free
from electrical cables or piping before
commencing drilling.

STEP 6
Move the cable from the top to the
bottom opening.
STEP 7
Allign the lamp above the base and
slide down to lock in place.

STEP 8
Insert your bulb into the front of the lamp,
rotating clockwise until tight. Take care not
to tighten too much to avoid breakage.
STEP 9
Reattach the lock screw using the hex
tool provided. Tighten until ush with the
outside surface of the lamp . Over tightening
may result in the screw becoming lost inside
the lamp.

STEP 10
Insert the lamp plug into your chosen wall
socket, making sure the power is switched off.
STEP 11
Switch the power on and rotate the dial on
your dimmer until the bulb lights up. Adjust
the dimmer for your desired light output.

Join the Community
Instagram: @tala | Facebook: talaHQ | Pinterest: TalaLED | Tag: lighttoliveby
Tala Studios, 25B Vyner Street, London E2 9DG | [phone] | [email protected]