Tanz THA400 Series User manual

PACKAGING CONTAINS
CD
21 Network camera 4Allen key 3Power adaptor 6Drill template 5Anchors and screws
CAMERA INSTALLATION
1IR lens
2Lens
3IR light sensor
4Sun hood
5Camera opening ring
6Bracket fixing bolts
7Bracket base
8LAN/POE cable
9Audio in (white)
10 Alarm out (orange-purple)
11 Audio out (red)
12 RS485 (white-yellow/green)
13 Alarm (red-black)
14 DC power
CAMERA DESCRIPTION
1Locate the drill template in the area where the camera would be
installed and drill the holes to screw the camera. 2Once the bracket plate is fixed to the wall or the ceiling
please assemble the camera to the plate, rotate the
camera bracket until the lock pins are engaged. Then
screw the bracket to the plate.
THA400 Series Quick Installation Guide
1
2
3
4 5 6 7
8
10
11
12
13
9

3The camera view direction can be changed by releasing the
bracket arm back bolts, once the camera has the right view
direction tighten the bolts to fix the camera.
4To open the camera from panel to have access to the lens focus
and zoom and also to the local storage slot please remove the
sun hood and by pressing the camera body down against a solid
surface rotate the lock ring clockwise.
CAMERA INSTALLATION
5
Once the camera body is opened please pull slowly the front
housing part, notice this part has cables connected to the camera
body. In the camera front part you would find the lens levers to
adjust focus and zoom (not lever if using a remote focus lens)
and also the reset button and local storage slot.
6To close the camera front part please align correctly the flanges
with the grooves; avoid cables to be damages while closing the
camera.
7Once the housing front ring has been aligned close the ring
tightly to avoid water and dust get into the camera. 8Once the camera is correctly installed follow the camera user
manual to have access to the setting interface.
THA400 Quick Installation Guide
Reset
Memory slot