Taramp's Tarsafe G2 User manual

BLOCK PART
Product Manual

- With the ignition off, hold the Reset button until the LED flashes 2 times (5 seconds).
Block Function:
- Activates when opening and closing the door with the ignition on and not pressing the
RESET button.
To cancel the valet function, turn on the ignition and press the Reset button for 1 second,
The LED will flash 1x (once) confirming cancellation.
- After 50 seconds, the LED flashes and the siren goes off if installed (not included),
another 20 seconds the progressive block initiates. Definitive blockage occurs after
another 30 seconds.
- To CANCEL the LOCKOUT, press the RESET button at any time, the LED will flash 1(once)
to indicate the lockout cancellation..
Operation
VALET Function:
- Temporarily cancels the Lock function. It is used when leaving the vehicle in a parking
lot, without the need to indicate the location of the Reset button (secret) to the valet.
Installation Scheme
4 - Green - Ground Signal Door Switch
5 - Black/Yellow - Alarm Siren Output
6- Red +12V
9 - Black- GND
3 - White/Black- LED +
2 - White/Black - Reset Button 8 - Black- LED GND
7 - Black- GND
10 - Blue - POST IGNITION
RESET
BUTTON
BLOCK
MAX 20A
1 - Green/White - Positive Signal Door Switch
LED

Technical Features
Supply Voltage
Consumption
Engine Lock
Siren Output
9 a 15 Volts
1 a 6 mA
Max. 20A
Only Use Dedicated Siren
TARAMPS, located at Rua Abílio Daguano, 274 Res. Manoel Martins - Alfredo Marcondes
- SP, ZIP 19.180-000, guarantees this product against design, manufacturing, assembly
and/or joint and several defects due to design flaws that make it unsuitable or
inappropriate for its intended use, for a period of 24 months from the date of purchase.
This warranty excludes:
Products damaged by incorrect installation, water infiltration, tampering by
unauthorized individuals;
In the event of a defect within the warranty period, TARAMPS' liability is limited to
repairing or replacing the device manufactured by it.
Damages of any type, resulting from problems with the product, as well as losses caused
by discontinuation of use.
Natural wear components, such as batteries and others;
Scratched or torn warranty seal;
Cases where the product is not used under regular conditions;
Defects caused by accessories, modifications or equipment attached to the product;
The product presents damage resulting from drops, impacts or the action of agents of
nature (floods, lightning, etc.);
Costs of removal and reinstallation of the equipment, as well as its transport to the
technical assistance post;
Warranty terms
Technical Support
A Taramps reserves the right to change the contents of this manual without prior notice or obligation to apply
the modifications to previously produced units.
Phone Number [phone] / 99749-3391
Factory technical assistance department:
Taramps Electronics - Rua: Abílio Daguano, nº 274 - ZIP 19.180-000
E-mail: [email protected]

MN_012493_R02
Fabricado por / Manufactured by:
TARAMPS ELECTRONICS LTDA
CNPJ / TAX ID: 11.273.485/0001-03
R. João Silvério, 121• Res. Manoel Martins
Alfredo Marcondes - SP
Indústria Brasileira - Made in Brazil