Taylor Hobson TalySurf 6 Installation and user guide

Page 1
How to Plug the electronic interface of the retrofit kit (TalySurf 6,
TalySurf 10, TalyStep, Surtronic 3, Surtronic 3P)
1 - List of components
The electronic interface for the Retrofit Kit is supplied with the following components :
q3 cables for power supply
q1 plug
q1 electronic box
The power supply of the interface box comes from the 5 V DC of the keyboard.
Depending on your keyboard or your PC, the 3 following possibilities are available to plug the interface box to
the keyboard.
Computer Keyboard
Interface Box
Power supply cables
Plug

Page 2
Computer
New keyboard format with
extension piece New keyboard format Old keyboard format
To plug the electronic interface, follow the steps below :
1. Switch off your computer
2. Unplug the keyboard
3. Plug the electronic interface according to the drawing above
4. Plug your instrument to the electronic interface (use the same cable as for the TalyProfile Dos version)
5. Re start your computer
6. Install the software and select the instrument connected (Menu Bank then Measurement, item Select
an instrument)