TBRC Warlock User manual

Thank you for purchasing a Warlock from TBRC Wings.
Kit Contents
1x Center wing panel
2x Outer wing panels
2x Tail booms
1x uselage
1x Coroplast horizontal stabilizer with built in elevator
2x Vertical stabilizers
12x Spars
2x Balsa ailerons
1x 2-56 Control rod with plastic clevis for elevator
1x Plastic control horn for Elevator
2x 2-56 Control rods with metal clevises for ailerons
2x Heavy duty aluminum control horns
1x Laser cut ply motor mount
8 eet 3mil laminate
3x Decals
Centre of Gravity (CG) is 1.25” (32mm) from the leading edge of the wing.

Step1
Trim 5mm off the trailing edge of the wing centre section. This is so that it fits perfectly
inside the booms.
Step2
Glue the outer wing panels to the centre wing section.

Step3
While the glue is drying on the wing panels cut spar channels into your fuselage and
booms and install the fiberglass spars.
Fuselage Sparing top, bottom and sides.
or the top and bottom the spars are to be cut to 11.75 inches.
or the sides they are to be cut at 9.75 inches

Boom Spars
Cut the boom spars to 9.75” length and install them on the top, bottom and sides of the
booms as shown.

Step4
Cut and add the spars to your wing. Be careful that you make sure the wing is straight
and without warp as the glue dries. Pay particular attention to the outer wing panels as
they are tapered. Be sure to spar top and bottom of the wing.
The main spar is 1.25” back from the leading edge of the centre section.
The secondary spar is 2” back from that first spar
The third spar is 1.75” back from the second spar
The main spar is also the Centre of Gravity (CG) line.

Step5
Laminate the wing with the supplied laminate. Cut out spaces in the laminate for where
the booms and fuselage will attach. This way when we attach them they will be glued
foam to foam for the best bond possible.
Step6
Laminate and install the ailerons to the outer portions of the wings. Install the aileron
servos so you can embed the wires along the wing under where the booms will be
installed.

Step7
Glue the booms and the fuselage to the wing, be sure that they are straight and parallel.
Step8
Glue in the horizontal stabilizer in the slot at the back of the booms. Be sure that the
elevator is at the back.

Step9
Glue the vertical stabilizers on the outside rear portion of the booms.
Step10
If you are making the Warlock in a pusher configuration attach the motor mount to the
rear of the fuselage.

Step11
Cut the fuselage battery plug to the desired height and glue it in place inside the fuselage.
Step12
Laminate the fuselage and the booms
Step13
Install the electronics. The elevator needs only small throws. Connect the pushrod to the
centre hole and the second hole down on the elevator control horn to decrease pitch
sensitivity.
Step14
Go out and fly.
Centre of Gravity (CG) is 1.25” (32mm) back from the leading edge of the middle wing
section.