TechNexion Vizionlink PCIE-VL-3120 User manual

Quick Install Guide
2-Port Vizionlink™ Frame Grabber Card (PCIE-VL-3120)
1. Identifying the Parts
FAKRA connectors
Follow the sequence to connect the cameras.
Grabber card gold nger
1
2
Firmware update switch
Note: To update the rmware, toggle the switch to the programming mode (right side) and strongly suggest operating this procedure by a technician.
2. How to Assemble the Card and the Cameras
1. Push down the grabber card into the PCIe slot directly.
2. Make sure the golden nger of the card is inserted rmly, and secure the card with a screw.
3. Connect the coaxial cable into the FAKRA connector of the frame grabber card on the I/O rear panel of the computer and the other end to a
camera. Follow the sequence mentioned in the Identifying the Parts section to connect other cameras.
3
2
1
INNOVATORS OF TECHNOLOGY

INNOVATORS OF TECHNOLOGY
For more information contact TechNexion sales
www.technexion.com [email protected]
For more information contact TechNexion sales
www.technexion.com [email protected]
3. How to Use the Camera
1. Enable the camera software built-in by the operating system or a supported third-party camera application.
2. Follow the software instructions to operate the camera.
• If the messages appear on the screen below, check the following (demonstrated with Windows built-in app):
The camera isn't connected or detected. Please examine the
connections between the camera, adapter, and computer.
The camera requires to update the rmware. Please check this issue
with a technician or contact us for help.
4. Getting Information
Select a compatible camera
https://www.technexion.com/products/embedded-vision/vizionlink
Software and development resources
https://www.technexion.com/support/