TeddyPardo Bluesound Node2i Troubleshooting guide

Teddy Pardo Bluesound Node2i Conversion Kit
Quick Startup Guide

Step 1: grab the rear panel cover from the
marked point and remove it. It is magnetic,
therefore no tools are necessary.

Step 2: remove the 4 screws that hold the rear
panel.

Step 3: carefully lift the upper cover.

Step 4: slowly and very carefully, lift open the
case cover. Make sure not to apply too much
force. Make sure not to touch or remove any of
the internal flat cables.

Step 5: Carefully unplug the two marked
connectors. Do not pull the wires.

Step 6: this is the result of step 5.

Step 7: remove 4 marked screws.

Step 8: Remove the two marked screws
from the rear panel.

Step 9: Remove the rear panel.

Step 10: Remove the rear power socket
holder.

Step 11: Grab hold the conversion
board filler panel and attach it to the
rear panel, use the original screws.

Step 12: place the conversion board
into the case.

Step 13: connect the plugs into the
main board.

Step 14: use the original screws for the
conversion board.

Step 15: replace the original power
socket holder.

Step 16: place the rear panel back.
Carefully place the upper cover, note
the marked holders.

Step 17: replace all rear panel screws.

Step 18: insert the panel cover to its
place, plug the barrel plug.
Unit is now ready !