TELink B91 User manual
Telink Proprietary 1
Telink Thread Demo Quick Start Guide
Telink Proprietary 2
Hardware
B91 Development board
Telink Proprietary 3
Hardware
Telink Burning Board
Use USB to connect PC and the Telink Burning Board, when the LED is off, the connection
is successful.
There is no need to install the driver.
Use dupont wire to connect Telink Burning Board and DUT.
3V3 -> 3V3(DUT)
SWM -> SWS(DUT)
GND -> GND(DUT)
Telink Proprietary 5
Take forming two nodes network as example , power on the node A and run
the following commands:
panid 1111
Form Thread Network
Telink Proprietary 6
Form Thread Network
channel 12
Telink Proprietary 7
Form Thread Network
ifconfig up
Telink Proprietary 8
Form Thread Network
thread start
Telink Proprietary 9
Form Thread Network
state
Now we know that node A has become the Leader.
Telink Proprietary 10
Form Thread Network
Power on the node B, run the same commands as node A, we can see that first
the node B becomes to the child, then change to the router after a few
seconds:
Telink Proprietary 11
Form Thread Network
Use the command “ipaddr” to get the IP addresses of node A.
Telink Proprietary 12
Form Thread Network
Run the “ping” command on the node B, we can see that the node B receives
the reply message from node A.
Other TELink Motherboard manuals
