Teqball One User manual

indoor / outdoor
INSTALLATION GUIDE

2/8
GENERAL
Thank you for choosing the Teqball One Table. We would like to give you some
advice for the installation. Please read and follow these instructions carefully.
SAFETY NOTICE
Any person handling or using the Teqball One table must follow the
instructions as described in this document. The person in charge of installing
and using the Teqball One table must ensure that the recommendations for
use given in this document, in the Assembly Instructions' document and in the
Owner’s Manual of the Teqball One table are seen by all users.
In communal use, it is strongly recommended that the instructions and
diagrams are displayed.
Before starting the installation, please make sure that all assembly instructions
are completed properly.
Installation must be carried out at least by two adults during all stages.
INSTALLATION
The Teqball One table must be installed by at least two adults followinq the
numerical order of the following instructions. Before installation, please check
that you have all the necessary screws and anchors from the package as well as
the required installation tools listed on page 3.
IMPORTANT: Move the Teqball One table carefully. It always should be carried by
at least two adult people lifting it. Never push or pull the Teqball One table on the
floor as it can cause damage to its parts.

INSTALLATION CONDITIONS
The recommended size of the Teqball court is 10 m long, 8 m wide and 4 m high.
The Teqball One table is positioned symmetrically in the middle of this 10 m x 8 m
rectangular area. If the Teqball One table is located outdoors, a 1,5 m x 1 m x
minimum 0,1 m deep concrete or asphalt base is required.
ATTENTION! The thickness of the asphalt or concrete base is very important.
If it does not reach the required 10 cm do not start the installation!
INSTALLATION TOOLS
2 pieces HILTI M12x50 galvanized hexagon screws (DIN 933; ISO 4017)
2 pieces HILTI HKD-SR M 12x50 drop-in (flush) anchors
HILTI HSD-G M12x50 or HSD-M 12x50 setting tool
Rotary hammer
Impact wrench
POWER REQUIREMENTS OF INSTALLATION TOOLS
3/8
Rotary hammer
Voltage: 220 V
Chuck:½ square drive
Maximum torque: 45 Nm
impact wrench
Voltage: 220 V
Single impact energy: 2 Joule
Full hammering frequency:
5200 impacts/min
1,5 m
8 m
10 m 1 m
4 m

INSTALLATION INSTRUCTIONS
4/8
Blow out the generated
dust from the holes.
ø 15 mm
55 mm
Drill 2 pcs of 15 mm diameter deep
hole with the rotary hammer 102 mm
far from each other in the middle of
the designated area.
Strike the anchors into the holes
with a hammer so that the top of
the anchors are flush with the
surface of the concrete.
min.1m
102mm
min.1,5 m

5/8
Position the table right over the
holes and then screw in the
galvanized hexagon screws. We
advise inserting the screws
gradually, making sure the table
is positioned correctly before
tightening. Required torque: max
30 Nm.
Use the HILTI HSD-G M12x50 or
HSD-M M12x50 setting tool to
widen the bottom of the anchors.
Remove the covering cap from the leg structure of
the Teqball One table, then lift the table and move
to position the table’s bores above the holes.

6/8
Put the covering cap back to its proper place.
Before using the table, please check if the table is fix and cannot be moved from
the installation area.

7/8
ENJOY TEQSPORTS!
1101-090-003B

Further information
www.teqball.com
[email protected]