The Source inStudio 8018049 User manual

Multimedia Bluetooth®
Speaker System
User Manual 8018049
INTRODUCTION
Thank you for purchasing the inStudio™Multimedia Bluetooth®Speaker
System. The speaker produces rich sound that will be ideal for your PC,
iPod®, iPhone®, MP3 player and other portable audio devices enabled with
a 3.5mm jack. Now you can seamlessly stream music from your iPad®,
iPhone®, Android™ device, laptop, or other Bluetooth®-enabled devices.
PACKAGE CONTENTS
• Subwoofer x 1
• Satellite speakers x 2
• User Manual x 1
• Audio cable x 1
WARNINGS
Caution! Read these instructions. Keep these instructions for future
reference. Heed all warnings. Follow all instructions.
• Do not use this apparatus near water–the appliance should not be used
near water or moisture (i.e. In a wet basement or near a swimming pool)
• Clean only with a dry cloth
• Do not install near any hear sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat
• Only use attachments/accessories speci ed by the manufacturer
• Unplug the apparatus during lightning storms or when unused for long
periods of time
• Refer all servicing to quali ed personnel
SPECIFICATIONS:
Output Power: 28W + 14W x 2 (RMS)
Speaker Unit: Full-Range Speaker: 2.5”, 4 Ohms
Subwoofer: 6.5”, 8 Ohms
Impedance: 8 Ohms/4 Ohms
Frequency Response: Satellite Amplifier: 250-20 kHz
Subwoofer Amplifier: 30-100 Hz
Power Supply: 120V~60Hz
Signal Input: RCA jack
S/N Ratio: ≥70dB
Separation: ≥ 40dB
Unit Size: Subwoofer: 235 x 245 x 235 mm (WxDxH)
Satellite: 140 x 138 x 134 mm (WxDxH)
SPEAKER CONNECTIONS
INSTRUCTIONS
1. Connect each satellite speaker to the subwoofer–red RCA plug into the
red audio output, and the white plug into the white audio output.
2. Connect the RCA cables into the input jacks matching red to red and
white to white. Connect the green adapter to your device.
3. Turn on the power and adjust the volume level to your desired
preference. A blue LED light surrounding the volume control glows
when power is turned on.
SPEAKER CONNECTIONS
INSTRUCTIONS FOR WIRED CONTROLS
1. Source Selection:
Press SOURCE button (10) to switch between Bluetooth® or AUX input. Blue
LED light for Bluetooth® input and red LED for AUX.
2. Bluetooth®Pairing:
a) For every new Bluetooth®device, you should pair the device with the
unit the  rst time. When you press the PAIR button (11), the blue LED
will fl ash quickly. Activate the Bluetooth®function on your device and
search for “inStudio 8018049” on the list. After pairing successfully, the
blue light will stay lit.
b) The unit will pair with your device automatically after the first pairing.
3. NFC Pairing:
Note: Please make sure that your smartphone/tablet supports NFC an
Bluetooth®over NFC.
a) Activate the NFC functionality in your smartphone or tablet.
b) Place the device on the NFC mark on the top side of the subwoofer and
keep it there until the speaker is paired and connected.
c) Move the smartphone or tablet and start playing your music.

THE FCC WANTS YOU TO KNOW
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed or used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Re-orient or relocate the receiving antenna;
• Increase the separation between the equipment and the receiver;
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected;
• Consult the dealer or an experienced radio/TV technician for additional
suggestions
Any changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment. Where shielded interface cables have been provided with
the product or specified additional components or accessories elsewhere
defined to be used with the installation of the product, they must be used
in order to ensure compliance with FCC regulation.
Industry Canada Notice
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
IC Number: 255A-8018049
CAN ICES-3(B)
The Source warrants that this product will be free from defects in materials and
workmanship for a period of one (1) year from the date of purchase. Within this
period, simply take the product and your proof of purchase to any The Source store
or participating dealer and the product will be replaced (where available) without
charge. Any product which has been subject to misuse or accidental damage is
excluded from this warranty.
This warranty is only applicable to a product purchased through The Source
company-owned stores or participating dealers in Canada where the warranty is
included with the product. While this warranty does not confer any legal rights other
than those set out above, you may have additional statutory rights which will vary
under the laws of the various countries, states, provinces and other governmental
entities in which The Source operates. This warranty is subject to all statutory rights
you may have in Canada.
Imported by:
The Source,
Barrie, Ontario, Canada, L4M 4W5
Manufactured in China
For product support please visit
www.thesource.ca
THE SOURCE – WARRANTY
© 2015 The Source.
All rights reserved. Please Recycle
The Bluetooth®word mark and logos are registered trademarks owned by
Bluetooth® SIG, Inc. Other trademarks and trade names are those of their
respective owners.