ThunderDog TH01THM User manual

Model: TH01THM
UNIVERSAL TABLET HEADREST MOUNT
Product image:
Assemble the mount:
1. Unscrew the cap and place the cap on the end of the gooseneck
2. Attach the tablet holder to the end of the gooseneck. You will hear a loud ”click” once
the holder is secure.
3. Tighten the cap to the tablet holder by turning the cap clockwise.

Installing the mount to your car headrest:
1. Adjust the width of two fasteners to attach to the posts on the rear seat headrest.
2. Press the two levers forward to lock the mount to the headrest posts.
3. Make sure the mount is positioned with the two-arm cradles at the bottom as shown
above.
Adjust the mount to fit your tablet:
1. Press the switch on the rear of the unit downward to unlock the mount.
2. Raise the single-arm cradle vertically to the desired position.
3. Insert your tablet into the two-arm cradles at the bottom of the mount.
4. Lower the single-arm cradle until it firmly grips the tablet.
5. Pull the switch on the rear of the unit to lock the tablet to the mount.

Removing your tablet from the mount:
1. Press the switch on the rear of the unit downward to unlock the mount.
2. Raise the single-arm cradle vertically to the desired position.
3. Remove your tablet from the mount.