Tiger V1 User manual

Tiger Lily Products TLP, Blinder, Bel, Escort, Valentine
PO Box 549 Tel303-678-9101 Cel: 720-635-3931
Niwot, CO, USA 80544 Fax [phone] Cel: 720-298-0557
Email [e-mail]
Web www.1stRadarDetectors.com
Rated #1, 360 Degree, High Performance, PRS1-STi-360™Prowler Remote™System
PROWLER Remote, PRS1-STi-360, PRS1-V-360, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Best in Test
Radar, Laser & Photo
Countermeasures
V1 Install Instructions, V1 & Valentine 1 Programming, November 2007
V1 Remote Installation Instructions
1. Use J Hooks hardware to install Remote Kit behind grille of vehicle, on top of Ski Rack, or just under the
bumper, or in the bumper (if a fiberglass bumper is available). The higher the better the performance. Drill
holes on the outer flanges of the aluminum enclosure, left and right sides, use J Hooks to hold package to
desired surface. A bracket is provided.
2. Ifyour vehicle is an SUV or pickup truck or larger, you can install under the bumper. If the install location is
good (typically just under the height of the bumper and approximately 18” back), the V1 willdetect radar to
the front with excellent sensitivity and to the rear with reasonable sensitivity. Do not install too low due to
potential road damage to the V1 Remote, when parking or going over parking lot bumps.
3. The cable protruding from the Remote Kit is the rear of the kit facing the engine compartment.
4. If installed behind the grille,rear radar detection will be significantlyreduced. Ensure no metal is in front of
the V1 Remote, and ensure V1 Remote is kept away from radiator to prevent heat damage. If installed
inside a front, foam core bumper, ensure no metal is in front of the V1 Remote.
5. Run the 14 foot cable into the cockpit and hook up according to electrical layout highlighted below. If the
cabling is ran differently than shown above, there will be no display on the Remote Concealed Display.
6. Call TLP on any questions you have or to order remote electronic display, audio control and cabling. The
Valentine One inside is a die-cast Magnesium enclosure, surrounded by a very sturdy Aluminum outer
enclosure.

Tiger Lily Products TLP, Blinder, Bel, Escort, Valentine
PO Box 549 Tel303-678-9101 Cel: 720-635-3931
Niwot, CO, USA 80544 Fax [phone] Cel: 720-298-0557
Email [e-mail]
Web www.1stRadarDetectors.com
Rated #1, 360 Degree, High Performance, PRS1-STi-360™Prowler Remote™System
PROWLER Remote, PRS1-STi-360, PRS1-V-360, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Best in Test
Radar, Laser & Photo
Countermeasures
How To Change V1 Remote and Valentine One Programming. Call us at 303-678-9101 if you
want help in changing your V1 modes of operation. Change Modes at your own risk!
I. How to enter the Programming Mode.
Starting with the Control Knob in the "off" position, Press and hold-in Knob and at the same time turn the Knob “on;”
continue holding in the Knob until all front-panel lights are on (takes about 5 seconds).
Release the Control Knob.
II. How to determine your software version.
Press and immediately release the Control Knob (shown at right) to display software version. The
software-version number is four digits that display one digit at a time in the Bogey Counter-example:
2.869.
Note your software number, then see the tables on the following pages on features programmable in your unit.
Press and immediately release the Control Knob to exit software-version display and go to Step 1 programming.
III. How to program your desired features.
The feature character is indicated in the "Bogey Counter" (1, 2, 3, 4, 5, 6, 7, 8, A, b, C, d, E, F, G, H, J, or u).
To select the next Feature Character in the sequence, press and immediately release the Control Knob.
The Feature State is indicated by direction arrows on the Radar Locator. The Feature State is changed by pressing and
holding the Control Knob until the arrow switches to the opposite direction (takes about 3 seconds). NOTE: If you need
to return to an earlier Character in the sequence above, we recommend you switch off the power momentarily, then
restart at step I above. The numerical program modes of interest are as follows:
US/Canadian/HK Frequency: #1 (X bandON =OFF = )Don’t change any other mode on US/Canada!
EUROPE / AU Frequency #1 (X band OFF = )
EUROPE / AU Frequency #2 (K = 24.125GHz : ON = )
EUROPE / AU Frequency #3 (Ka band ON = )
EUROPE / AU Band #4 (Laser ON = )
EUROPE / AU Frequency #4 #H (Ku ON )
EUROPE / AU Frequency #J (POP3 ON = )
EUROPE / AU Frequency #U (Euro Ka = 34.2GHz, Narrowband Ka ON = )
Do not change any other mode!

Tiger Lily Products TLP, Blinder, Bel, Escort, Valentine
PO Box 549 Tel303-678-9101 Cel: 720-635-3931
Niwot, CO, USA 80544 Fax [phone] Cel: 720-298-0557
Email [e-mail]
Web www.1stRadarDetectors.com
Rated #1, 360 Degree, High Performance, PRS1-STi-360™Prowler Remote™System
PROWLER Remote, PRS1-STi-360, PRS1-V-360, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Best in Test
Radar, Laser & Photo
Countermeasures
IV. How to exit the Programming Mode.
Switch power off, or unplug. The changes you programmed will be retained in memory.
V. How to tell if V1 has been changed from factory settings.
If the unit has been changed, P will appear briefly in the Bogey Counter soon after V1 is switched on
(after the lamps-on test, but before the Mode indicator appears.)
On V1s with serial numbers ending in 0600 or higher, a flashing red LED just to the right of the Bogey
Counter during the sequence above indicates that Ku coverage has been activated.

Tiger Lily Products TLP, Blinder, Bel, Escort, Valentine
PO Box 549 Tel303-678-9101 Cel: 720-635-3931
Niwot, CO, USA 80544 Fax [phone] Cel: 720-298-0557
Email [e-mail]
Web www.1stRadarDetectors.com
Rated #1, 360 Degree, High Performance, PRS1-STi-360™Prowler Remote™System
PROWLER Remote, PRS1-STi-360, PRS1-V-360, PRS2-V, PRS2-STi, PRS3-V, PRS3-STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999-2008.
Got Performance™
Best in Test
Radar, Laser & Photo
Countermeasures
Euro K band is at 24.125GHz. Wideband
Ka is turned off when Euro Ka is turned
on. Ku is used in UK, Netherlands,
Northern France, Taiwan, Belgium, but
not in the USA as of Jan07.
The Euro Mode and Ku band are separate
features and require separate activation.
Euro Mode is a narrowband Ka used in
Europe and Australia on photo speed traps.
When Euro Mode has been activated, upon
power up you will see the sequence "E," "u,"
"r" appear in the Bogey Counter. When the
power-up sequence is complete, the Bogey
Counter will show either "U" or "u." Pressing
the Control Knob will toggle between them.
Select "U" to enable both K and narrowband
Ka (Photo) bands. Select "u" to enable only
narrow Ka band.
Euro Ka (Big U) mode detects:
Ka POPIII 33.8GHz
KA Narrowband 33.97GHz to 34.65GHz
after July 2006 (Rev 3.8.5.1 and later
KA Narrowband 34.2GHz to 34.45GHz
before July 2006
K 24.125GHz and K POPIII radar
X turned off
Euro Ka (little u) mode detects:
Ka POP 33.8GHz
KA Narrowband 33.97GHz to 34.65GHz
after July 2006 (Rev 3.8.5.1 and later
KA Narrowband 34.2GHz to 34.45GHz
before July 2006
All K turned off
All X turned off
Euro Ku: 13.45 GHz