Tiltall BH Series User manual

Center ball professional head
Tiltall BH Series Ball Heads
BH-10/ BH-20/ BH-30
A STRONG, DURABLE BALL HEAD
PERFECT FOR POINT-AND-SHOOT AND
DSLR CAMERAS.
Features include:
• 30/ 36/ 44 ball head with
quick release plate
• Made of aluminum
aircraft
• Locking knob with friction
control
•
scale
360° panning graduated
• Quick release plate
with 1/4-20 screw
• Built-in two bubble
levers
www.tiltalltripod.com
Contents: One ball head, and a quick release plate.

A
B
C
D
E
F
Using The Ball Head
The ball head is very compact and easy to use, and offers solid
camera support with fluid smooth movements. It features a
single ball-locking knob (D) with an adjustable drag control
screw (E), and a separate pan-control lock (C). The calibrated
panning scale (F) allows you to reference any movements. There
is a convenient slot on the ball head that allows you to change
your camera from horizontal to vertical format. To alter the
position of your camera, simply turn the signal ball-locking knob
counterclockwise. The further you turn the knob, the looser the
friction on the ball becomes, allowing you quicker and larger
movements.
You can increase or decrease the amount of friction on the
ball with the adjustable drag control screw. First, turn the single
ball-locking knob (D) clockwise to fully lock ball. Then rotate the
adjustable drag control screw (E) clockwise to increase friction,
or counterclockwise to decrease. Test your setting by loosening
the single ball-locking knob. you may need to repeat this
procedure to find the desired setting when changing equipment.
Noted: Always support the camera while loosening the signal
ball locking knob. Be sure the signal ball-locking knob is fully
locked after setting the adjustable drag control screw. Do not
overtighten knobs.
www.tiltalltripod.com
Attaching Camera To The
Quick-Release (QR) Plate
First remove the QR plate (K) from
the head by rotating the locking knob
(L) counterclockwise until it stops.
Mount the QR plate (K) to the camera
by screwing the 1/4”-20 male treaded mount into the camera’s
base-plate mount using the pop-up handle on the under side of
QR plate. Before fully tightening, be sure that camera is
parallel to the plate with the lens side of the camera. When fully
tightened, rotating clockwise the locking knob against QR plate.
Mounting Camera To
The Ball Head
With camera facing forward, insert
the QR plate under the lip on the
ball head and put down the camera
then rotating the locking knob (L)
clockwise until fully tighten, holding plate in place.
To remove the camera from the ball head, simply release the
locking knob counterclockwise until it stops and, while holding
the camera securely in one hand, and released from head.
A: Quick release plate
B: Quick release clamp
locking knob
C:
knob
360° panning locking
D: Ball locking knob
E: Friction control screw
F: 360° panning scale