Time Living Braunston User manual

LIVING
Assembly Instructions
Hardware List Parts List
1. M8 x 30mm JCBBScrew Spes
Iiiltatti:q
A. Headboard Ipc
2. M3.S x 16mm Screw Spes ~
B. Footboard Ipc
3. MS Allen Key IpcV
C. Side rails 2pcs
4. MS x 20mm JCEBScrew Spes ~ D. Centre Rail Ipc
5. End slat caps 24pcs ~ E.Width Bar 2pcs
6. Centre slat caps 12pcs ~"'~ F. Centre Supporr less
30(5
, ~
.
G.Slats 24pcs
~
H. Corner Feet 4pcs
Note: Please ensure that all hardware is kept Note: Please use the above check list to
out of the reach of children. ensure all hardware is included.
Step 1
1.1 Attach the corner feet (H) to the headboard
(A) & footboard (B) with the M8 x 20mm screws
(4),
Note: There are four holes on each corner I
foot: however, you will only require two of I
them. Do not over-tighten the screws as this I'
may cause damage to the thread.
1.2 Attach the centre support legs (F) to the
centre rail (D) by screwing them into their
corresponding holes. I
I

Step 2
L ~. _
2,1. Attach the side rails (e) to the headboard (A)
& footboard (B) with M8 x 30mm screws (1).
Note: Do not fully tighten the screws before
assembly is complete. Once completed do
not over-tighten the screws as this may cause
damage to the thread.
Step 3 ~ Place the centre rail (D) into its
corr esnondine J:-ackets on the
r.ecoboard (A.) and Footboard (B).
3.2 Attach the Width Bars (E) to the
inside of the side rail (C) and the
side of the centre rail (D) using the
M3.5 x 16mm Wood Screws (2).
Note: There are no designated
holes for the screws to go into.
You simply need to align the
width bar (E) and screw into the
wooden bar on the side rail (e)
and into the side of the centre
rail (D).
3.3 Insert the slats (G) into the end
slat cap (5) and fix it to the
corresponding holes on the side rail
(C).

Step 4
-_. __ ._._._--j
L._
4.1 Slot the first slat (G) into the
centre slat cap (6) and insert a
second slat (G) into the centre slat
cap (6) on the opposite side. Attach
an end slat cap (5) to the second slat
before pressing the caps into the
corresponding holes on the centre
rail (D) and side rail (C).
--~--~--.-.----------
5.1. Your new Braunston bed frame
is now complete. Once you have
positioned the bed please ensure
that the centre support legs are
vertically aligned before the
mattress is placed on the bed frame.
5.2. To ensure your bed frame
remains in optimum condition
please periodically check all screws
and tighten if necessary.
Note: If the bed is dragged or
moved the centre support legs
may no longer be vertically
aligned. You must ensure that in
the event of the bed moving the
legs are checked to ensure they
are aligned. If not this may cause
the centre support bar to
collapse.
Any questions? Call our friendly customer service team on [phone]
(Open from 9am-5pm Mon-Fri),