timkid CLEXO User manual

ASSEMBLY INSTRUCTIONS CLEXO
timkid GmbH | Mühlendeich 15 | 19303 Dömitz | 03875836933 | inf[email protected]
www.timkid.de

ALL PARTS FOR THE ASSEMBLY OF CLEXO
ASSEMBLY INSTRUCTIONS
Insertion of the back leg.
Fixation with cross bolt nut
(is already present in the leg)
IMPORTANT! The nut must point
inwards, the slot must be vertical.
DONE!
A 2x bolts for fastening
the table top
B 1x sleeve nut
C 1x for support to the
table top 6x10 mm
D 1x for fastening the
table support 6x25 mm
E 2x for fastening the
seat plate 6x50 mm
F 2x grub screw fixation
2x footrest
G 2x for footrest 6x15 mm
1x table support
Do the same with the front leg.
Tighten the seat plate with the screws E.
Screw the two bolts A into the table top.
Insert the table top with the bolts into
the holes until it rests rmly.
Screw in grub screws F
Insert sleeve nut Bfrom the inside.
Connect screw Dwith table support
and sleeve nut B.
Fasten screw Cwith the table support
into the table top.
Use the screws Gto screw the footrests
to the required height.
B
A
E
G
F
D
C