TODAAIR In1212YW-H Parts list manual

To Setup In1212YW-H
1) Please set your laptop / PC with IP address with 192.168.2.100 and
subnet mask with 255.255.255.0
2) Open a browser , type in http://192.168.2.1 to open AP
configuration page.
Key in admin in the Password field and click login
3)
admin
Lan Cable Connection Method
48V POE
Injector
POE LAN
Router / Switches
Cat5e / Cat6 Cable

5) Always remain the Mode Settings as AP Mode for this wireless device
Make sure your router modem was ready and online to internet ,
then this wirelss AP IN1212YW-H will auto find the available router
to get connected online. Successful WAN connection will show as
example as below.
4)

7) You can control the download or upload bandwidth by enable the
Bandwidth Control in Qos Setting. This may useful for managing the
wireless AP for certain group of user to access internet with different
bandwidth control within a group of wireless APs. If Bandwidth Control
set to disable , wireless AP will provide the maximum bandwidth limited
provided by your ISP
You can change the LAN IP of the wireless AP or leave it default and
DHCP Service always remain disable.
6)

9) Wireless Security Setting were able to set with different SSID name with
its Safe Mode Type ,Encryption Type and Password respectively. If a
group of these wireless AP set as the same SSID, Safe Type ,Encryption,
and password ,then the mobile device connected could able to perform
roaming in between the groups of wireless APs
Setup was done, and you could able too connect your mobile
devices to these wireless APs
10)
In Wireless Setting , you can preset your 2.4Ghz Mode wireless SSID
and 5.0Ghz Mode wireless SSID respectively in 2.4G Basic Settings
and 5G Basic Settings , remain the Channel,Work Mode, and
Transmitt Power as default.
8)