Topaz Systems GemView 10 User manual
2 www.topazsystems.com Back to Top
GemView 10 & 10 Touch Tablet Display User Manual
Table of Contents
Compliance Information.......................................................................................................... 4
Important Safety Instructions................................................................................................. 5
Copyright Information............................................................................................................. 6
Introduction.............................................................................................................................. 6
Packing List............................................................................................................................ 6
Product Overview................................................................................................................... 7
Front and Side View .......................................................................................................................7
Rear View.......................................................................................................................................8
Interactive Electromagnetic Pen ..................................................................................................... 8
Installation................................................................................................................................ 9
Connect Tablet Display to PC ................................................................................................ 9
Connect Pen to Tablet Display............................................................................................. 10
Install DisplayLink Driver...................................................................................................... 10
Configure Tablet Display for Installation............................................................................... 10
Install GemView Tablet Display Driver ................................................................................. 12
Configure Tablet Display for Pen Input................................................................................. 12
Install Bundled Topaz Software............................................................................................ 15
Mounting Information............................................................................................................ 15
GemView 10 Touch Tablet Display Set-Up.......................................................................... 16
Troubleshooting .................................................................................................................... 18
Screen Problems.................................................................................................................. 18
Problems of Interactive Electromagnetic Pen....................................................................... 18
3 www.topazsystems.com Back to Top
GemView 10 & 10 Touch Tablet Display User Manual
Table of Contents
Product Specification............................................................................................................ 19
Screen.................................................................................................................................. 19
Interactive Electromagnetic Pen........................................................................................... 20
Appendix ................................................................................................................................ 21
Replace the Pen Tip............................................................................................................. 21
4 www.topazsystems.com Back to Top
GemView 10 & 10 Touch Tablet Display User Manual
Compliance Information
This device complies with part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Warning: You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
CE Conformity for European Countries
The device complies with the EMC Directive 2004/108/EC and Low Voltage Directive
2006/95/EC.
Following information is only for EU-member states:
The mark shown to the right is in compliance with the Waste Electrical and Electronic
Equipment Directive 2012/19/EU (WEEE). The mark indicates the requirement NOT
to dispose the equipment as unsorted municipal waste, but use the return and collection
systems according to local law.
If the batteries, accumulators and button cells included with this equipment, display
the chemical symbol Hg, Cd, or Pb, then it means that the battery has a heavy metal
content of more than 0.0005% Mercury or more than, 0.002% Cadmium, or more than
0.004% Lead.
5 www.topazsystems.com Back to Top
GemView 10 & 10 Touch Tablet Display User Manual
Important Safety Instructions
1. DO NOT place objects on top of the device, as objects may scratch the screen.
2. DO NOT expose the device to dirty or dusty environments.
3. DO NOT place the device on an uneven or unstable surface.
4. DO NOT insert any foreign objects into the device.
5. DO NOT expose the device to strong magnetic or electrical field.
6. DO NOT expose the device to direct sunlight as it can damage the LCD Screen. Keep it
away from heat sources.
7. DO NOT use the device in the rain.
8. Please check with your Local Authority or retailer for proper disposal of electronic
products.
9. The device may produce some heat during normal operation or charging. To prevent
discomfort or injury from heat exposure, DO NOT leave the device on your lap.
10.POWER INPUT RATING: Refer to the rating label on the device. Only use accessories
specified by the manufacturer.
11. DO NOT use any sharp object to tap the screen.
12.Clean the touch screen with a soft cloth. If needed, dampen the cloth slightly before
cleaning. Never use abrasives or cleaning solutions.
13.Disconnect the device from an electrical outlet and power off before cleaning the device.
14.DO NOT disassemble the device. Only a certified service technician should perform
repair.
15.Users have to use the connection to USB interfaces with USB 2.0 version or higher
This manual suits for next models
3
Table of contents
