Toptech ACE210 User manual

USB/SD AUX FM BT
AC110V-220V,50/60Hz MADE IN CHINA
USER MANUAL
MODEL: ACE210

ATTENTION!
The USB port of our speaker is for USB Flash only,
please do NOT connect it with power bank, hardware or
cell phone etc devices. It will caused the damage of USB
port and display screen!
FRONT PANEL FUNCTION OPERATION INSTRUCTION
Control panel
AC INPUT
LED POWER
POWER
ANT
AUX
VOLUME
BASS
TREBL E
MIC2
MIC1
MIC.VOL
ECHO
MO D E
LED
US B
SD / MM C/ M M S
AC 110V
50/60Hz
AC 220V
50/60Hz
1
2
3
4
5
6
7
8
9
10
11
12
13 14
15
16 17
18
1.USB/SD card slot
2.Power on/off LED indicator
3.Input(Mp3)button
4.Previous song in Mp3 mode
5.Play/Pause
6.Next song in Mp3 mode
7.Wired Mic. input jack
8.Mic.volume control knob
9.Echo volume control knob
10.Treble volume control knob
11.Bass volume control knob
12.Master volume control knob
13.RCA audio input jack
14.FM Antenna
15.LED ON/OFF switch
16.Power ON/OFF switch
17.AC110V-220V input for charging
18.Voltage selector AC110V to AC220V
MODE
MUTE
STOP
VOL+
VOL-
CH+
CH-
REPE E/R
0
987
6
5
4
123
1
2
3
4
5
6
7
8
9
10
11
12
1.Power key
2.Choose signal input
3.Stop play on Mp3 mode
4.VOL+
5.Play/Pause,long-press
6.Last song/Last FM channel
7.VOL-
8.Choose USB input signal
9.Choose song number directly
10.Mute key
11.Next song/Next FM channel
12.Different sound field effect

§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between theequipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.