Trend Sports SCORPION SP49 User manual

Read This Before Operating
IMPORTANT
DO NOT RETURN THE SCORPION MACHINE TO THE RETAIL STORE WHERE PURCHASED.
CALL TOLL FREE: [phone].
CUSTOMER SERVICE
TREND SPORTS is dedicated to your customer satisfaction. If you experience any trouble with the operation
of the Scorpion Soft Toss Machine contact us at: [phone] or go to our website at www.TrendSports.com.
SCORPION BALL RECOMMENDATION
Trend Sports recommends using Slider Lite-Balls, or Heater Baseballs in your Scorpion Soft Toss Machine.
WARNING: THIS PRODUCT IS TO BE USED BY ADULTS ONLY. MAKE SURE MACHINE IS TURNED OFF BEFORE
ASSEMBLY! KEEP HANDS AND ALL BODY PARTS AWAY FROM BALL ENTRY AND EXIT! SERIOUS INJURY MAY
OCCUR IF USED INCORRECTLY!
WARNING!
Stayclearof ball exitwhen machine
is operating. Keep hands and fin-
gers clear of motor operation.
Use under adult supervision only.
• Please be sure to read all of the instructions before using the Scorpion Soft Toss Machine
to insure the machine is working properly.
• Parents: Your child should be made aware of potential dangers when using
any electrical powered product.
• Never put your fingers into the Scorpion while it is operating.
• The Scorpion is not a toy and an adult should supervise children. It is very important
that the batter make sure the area is clear before swinging bat.
• Stay clear of the ball opening while the Scorpion is operating.
Children should be advised of any danger and appropriate precautions should be taken.
95 West 650 South • St. George, Utah 84770
PH: 800-492-9334 • PH: 435-656-1756
Fax: [phone]

Rubber Tip Legs
(Qty 3)
(B)
(H)
SCORPION PARTS LIST
SCORPION ASSEMBLY INSTRUCTIONS
STEP 1: Locate Part (A) and insert Parts (B) into the tripod base
as shown. (Make sure the push-pins insert into the tripod base
and lock.)
A/C Plug (Qty 1)
(A)
(C)
Pole Sections
(Qty 2)
(D)
Spiral Bottom
(E)
Spiral Top
(F)
Feeder Base
Steel Wire
Ball Ramp
(A)
(B) (B)
(B)
STEP 2: Insert Parts (C) into each other and then into Part
(A), the tripod base, as shown. (Make sure the push-pins
insert into each section and lock.)
(C)
(A)

SCORPION ASSEMBLY INSTRUCTIONS (Continued)
Do not use any A/C Plug Adapter
other than the one provided
with the Scorpion.
8 hour battery packs are
available to turn your Scorpion
into a portable battery
operated machine.
Make Your Scorpion Battery Operated
Call 1-800-492-9334 to order an 8 hour battery
pack for your Scorpion Soft Toss Machine.
STEP 3: Take Part (F) and push it onto Part (C) base as shown.
(D)
STEP 4: Push Part (D) onto Part (F) by aligning the notches
and pushing down firmly. Do the same for Part (E) onto Part
(D) as shown.
(C)
(A)
(F)
(C)
(E)
(D)
(F)
(F)
STEP 5: Insert the Ball Ramp Part (H) into the holes where
the balls exit the spiral on Part (F).
STEP 6: Plug the Ball Feeder wire from Part (D) into the
socket on the back of Part (F). Plug the Power Adapter into
the socket on the front on Part (F).
(Ball Feeder Power Socket) (Power Adapter Socket)
95 West 650 South • St. George, Utah 84770
PH: 800-492-9334 • PH: 435-656-1756
Fax: [phone]

SCORPION OPERATION INSTRUCTIONS
Model# SP49
Balls: The Scorpion will use any regulation sized ball.
Trend Sports recommends Slider Synthetic Leather Lite-Balls,
Slider Soft Lite-Balls, or Heater Baseballs
NOTE: The Scorpion has two battery compartment.
Compartment (1) connects to the optional Crusher 8 Hour Battery.
Compartment (2), located on the bottom of Part (F), takes four C
Batteries (not included)
(1) (2)
95 West 650 South • St. George, Utah 84770 • PH: 800-492-9334 • PH: 435-656-1756 • Fax: [phone]
Power: The Scorpion Power Adapter will plug into any
standard wall outlet. After connecting the Scorpion to
electric or battery power, turn on the machine with the
power switch located on the side of Part (F).
The Scorpion will also run on battery power.
There are two separate battery compartments built
into the Scorpion Soft Toss Machine.
Make Your Scorpion Battery Operated
Call 1-800-492-9334 to order an 8 hour battery
pack for your Scorpion Soft Toss Machine.