TRENDnet TPL-302E2K - Powerline AV Fast EN Adapter User manual

TPL-302E
TPL-302E2K
H/W: V1
Quick Installation Guide

Table of Contents
Table of Contents
Version 02.18.2009
English .....................................................................................................
Troubleshooting ........................................................................................
1. Before You Start
2. ....................................................................................
................................................................................
How to Install
1
1
2
7

?TPL-302E
?Utility CD-ROM
?Quick Installation Guide
Package Contents
1. Before You Start
English
1
System Requirements
Utility Requirements
Application
?
?A Desktop or Laptop PC with Network Adapter Installed
?CPU: 300MHz or above / 800MHz or above (Windows Vista)
?
?Existing HomePlug AV network
?Existing 10/100Mbps wired network when TPL-302E is used as a bridge
device
C
Memory: 256MB or above / 512MB or above (Windows Vista)
D-ROM drive
?
?Microsoft Net Framework 1.1
Windows 2000/XP/Vista
Internet
Internet

2. How to Install
English
2
Important! DO NOT install the TPL-302E until instructed to do so
Note: If Microsoft Net Framework 1.1 is installed on your computer skip to step
7. If Microsoft Net Framework 1.1 is not installed continue to step 5.
1. Insert the Utility CD-ROM into
your computer's CD-ROM Drive
and then click Install Utility.
3. Select No, I will restart my
computer later (Windows 2000
only).
For Windows Users
2. Follow the InstallShield Wizard
instructions.
4. Click Finish.

English
3
7. Restart your computer.
Note:
1. DO NOT plug the TPL-302E into a power strip or surge protector.
2. In order for the TPL-302E to see each other, each unit must be on the same
circuit breaker box.
3. A maximum of 16 TPL-302E can be networked.
6. Follow the setup instructions and
then click OK.
8. On the back of the each TPL-302E,
copy down the 12 digit device
password with the dashes in
between. The device password is
case sensitive.
5. Select I agree, then click Intall.

Outlet
English
4
9. Plug the TPL-302E into an
available power outlet.
10. Connect a CAT-5 cable from the
TPL-302E to an available LAN
port on your router (e.g. TEW-
633GR). Then connect a CAT-5
cable from an available LAN port
on your router to your computer.
12. Double-click the Powerline AV
Utility on your desktop.
11. Plug a second TPL-302E into an
outlet where your remote PC or
network appliance is located.
13. Select Remote from the Device
Selection dropdown box.
Note: Remote refers to the TPL-302E that is connected to your remote PC or
network appliance.
Outlet

14. Click Network ID.
15. If you would like to change the
Network ID, enter the desired ID.
Then enter the 12 digit DAK
(device) Password for the
Remote TPL-302E (see step 8).
Note: The DAK (device)
Password is case sensitive. You
must enter the DAK (device)
password with the dashes. For
example: XXXX-XXXX-XXXX-
XXXX. Then click Save Changes.
Wait 30 seconds while changes
are being saved.
16. If Device Selection does not
automatically switch to Local,
select Local from the dropdown
list.
Note: The default network name is TRENDnet. If the network ID of your
existing Powerline network is NOT TRENDnet, you must change this in the
utility.
Note: Local refers to the TPL-302E that is connected to an Ethernet
connection on your network or an available LAN port on your router.
English
5

Outlet
English
6
Your installation is now complete.
For detailed information regarding the TPL-302E configuration and advanced
settings, please refer to the User's Guide included on the Utility CD-ROM or
TRENDnet's website at www.trendnet.com
17. Enter the same Network ID that
you entered in Step 15. Then
click Save Changes.
18. Connect a CAT 5 cable from the
TPL-302E into your remote PC or
network appliance.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at: www.trendnet.com/register
Thank you for choosing TRENDnet

Q1:
A1:
Q2:
A2:
Q3:
A3:
I inserted the TPL-302E CD-ROM into my computer's CD-ROM Drive and the
installation menu does not appear automatically. What should I do?
If the installation menu does not appear automatically, click Start, click Run,
and type D:\Autorun.exe where "D" in "D:\Autorun.exe" is the letter assigned to
your computer's CD-ROM Drive. And then click OK to start the installation.
I have verified that my Powerline device is connected to my workstation, but I
cannot detect other Powerline devices. What should I do?
First, verify that you are using Cat 5 Ethernet cables. Second, open up the
Powerline AVUtility and click scan. Third, plug the remote device near the local
device. Press on the quick setup button on the front of the local device and
remote device for 10 seconds to reset the device. Then press on the quick setup
button on the local device for 3 seconds. Then press on the quick setup button on
the remote device for 3 seconds. Fourth, verify that the power outlet the TPL-302E
is plugged into is on the same electrical power distribution and/or circuit breaker
box.
I can detect my Powerline devices on my Powerline network, but I cannot
connect to the Internet. What should I do?
First, make sure you are not connecting the device into a power strip or surge
protector. Second, make sure that your Router is connected to the internet. Third,
verify that the TCP/IP settings are set to Obtain an IP address automatically.
7
Troubleshooting
1. Go into the Control Panel and double-click the
Network Connections icon, and then right-click the
Local Area Connection icon and then click
Properties.
2. Click Internet Protocol (TCP/IP) and then click
Properties. Click on Obtain an IP automatically and
then click OK.

Q4:
A4:
Q5:
A5:
When I try to configure a remote device, an error message appears. What
should I do?
First, make sure you copy down the 12 digit device password. Second, enter
the 12 digit device password in the utility. You need to enter dashes. For
example: XXXX-XXXX-XXXX-XXXX.
I have a HomePlug 1.0 or HomePlug turbo network. Can I use this with my
network?
The TPL-302E is not backwards compatible with HomePlug 1.0 or HomePlug
turbo.
If you still encounter problems or have any questions regarding the TPL-302E, please
refer to the User's Guide included on the Utility CD-ROM or contact TRENDnet's
Technical Support Department.
8

9
Limited Warranty
- 3-Year Limited Warranty
TRENDnet warrants its products against defects in material and workmanship, under
normal use and service, for the following lengths of time from the date of purchase.
TPL-302E/TPL-302E2K
If a product does not operate as warranted above during the applicable warranty period,
TRENDnet shall, at its option and expense, repair the defective product or deliver to
customer an equivalent product to replace the defective item. All products that are
replaced will become the property of TRENDnet. Replacement products may be new or
reconditioned.
TRENDnet shall not be responsible for any software, firmware, information, or memory
data of customer contained in, stored on, or integrated with any products returned to
TRENDnet pursuant to any warranty.
There are no user serviceable parts inside the product. Do not remove or attempt to
service the product through any unauthorized service center. This warranty is voided if
(i) the product has been modified or repaired by any unauthorized service center, (ii) the
product was subject to accident, abuse, or improper use (iii) the product was subject to
conditions more severe than those specified in the manual.
Warranty service may be obtained by contacting TRENDnet office within the applicable
warranty period for a Return Material Authorization (RMA) number, accompanied by a
copy of the dated proof of the purchase. Products returned to TRENDnet must be pre-
authorized by TRENDnet with RMA number marked on the outside of the package, and
sent prepaid, insured and packaged appropriately for safe shipment.

10
WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE
AS WARRANTED ABOVE, THE CUSTOMER’S SOLE REMEDY SHALL BE, AT
TRENDNET’S OPTION, REPAIR OR REPLACEMENT. THE FOREGOING
WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER
WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF
LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. TRENDNET
NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT
ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION,
MAINTENANCE OR USE OF TRENDNET’S PRODUCTS.
TRENDNET SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND
EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES
NOT EXIST OR WAS CAUSED BY CUSTOMER’S OR ANY THIRD PERSON’S
MISUSE, NEGLECT, IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED
ATTEMPTS TO REPAIR OR MODIFY, OR ANY OTHER CAUSE BEYOND THE
RANGE OF THE INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER
HAZARD.
LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDNET
ALSO EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER
BASED IN CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL,
CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND,
OR FOR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF
INFORMATION OR DATE, OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN
CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE, USE,
PERFORMANCE, FAILURE, OR INTERRUPTION OF THE POSSIBILITY OF SUCH
DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR, REPLACEMENT, OR REFUND
OF THE PURCHASE PRICE PAID, AT TRENDNET’S OPTION. THIS DISCLAIMER OF
LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED
HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE.
Governing Law: This Limited Warranty shall be governed by the laws of the state of
California.
Note: AC/DC Power Adapter, Cooling Fan, Power Supply, and Cables carry a 1-Year
Warranty

Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may
cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO
OPERATE THE EQUIPMENT.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recycle where facilities exist. Check with you Local
Authority or Retailer for recycling advice.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria
existente en el pais o zona de instalación.

Copyright ©2009. All Rights Reserved. TRENDnet.
Product Warranty Registration
Please take a moment to register your product online.
Go to TRENDnet’s website at http://www.trendnet.com/register
20675 Manhattan Place
Torrance, CA 90501
USA